ATA6630 ATMEL [ATMEL Corporation], ATA6630 Datasheet - Page 6

• Manufacturer Part Number: ATA6630
• Description: Negative Trigger Input for Watchdog
• Manufacturer: ATMEL [ATMEL Corporation]

3.13
3.14
3.15
3.16
3.17
3.18
3.19
6
TM Input Pin
KL_15 Pin
INH Output Pin
Reset Output Pin (NRES)
WD_OSC Output Pin
NTRIG Input Pin
Wake-up Events from Sleep or Silent Mode
ATA6628/ATA6630 [Preliminary]
The TM pin is used for final production measurements at Atmel
be always connected to GND.
The KL_15 pin is a high-voltage input used to wake up the device from Sleep or Silent Mode. It
is an edge-sensitive pin (low-to-high transition). It is usually connected to ignition to generate a
local wake-up in the application when the ignition is switched on. Although KL_15 pin is at high
voltage (V
directly to GND if you do not need it. A debounce timer with a typical Tdb
implemented.
The input voltage threshold can be adjusted by varying the external resistor due to the input
current I
ceramic capacitor of 100 nF are recommended. With this RC combination you can increase the
wake-up time Tw
You can also increase the wake-up time using external capacitors with higher values.
The INH Output pin is used to switch an external voltage regulator on during Normal and
Fail-safe Mode. The INH Output is a high-side switch, which is switched-off in Sleep and Silent
Mode. It is possible to switch off the external 1 k master resistor via the INH pin for master
node applications.
The Reset Output pin, an open drain output, switches to low during VCC undervoltage or a
watchdog failure.
The WD_OSC Output pin provides a typical voltage of 1.2V, which supplies an external resistor
with values between 34 k and 120 k to adjust the watchdog oscillator time.
If the watchdog is disabled, this voltage is switched off and you can either tie to GND or leave
this pin open.
The NTRIG Input pin is the trigger input for the window watchdog. A pull-up resistor is imple-
mented. A negative edge triggers the watchdog. The trigger signal (low) must exceed a
minimum time t
• LIN-bus
• WAKE pin
• EN pin
• KL_15
KL_15
Batt
), it is possible to switch the IC into Sleep or Silent Mode. Connect the KL_15 pin
. To protect this pin against voltage transients, a serial resistor of 47 k and a
trigmin
KL_15
to generate a watchdog trigger.
and, therefore, the sensitivity against transients on the ignition KL_15.
®
. In normal application, it has to
Kl_15
9117E–AUTO–07/10
of 160 µs is