LF13-WBJ-11P HIROSE [Hirose Electric], LF13-WBJ-11P Datasheet - Page 9

• Manufacturer Part Number: LF13-WBJ-11P
• Description: Miniature Waterproof Shielded Connectors
• Manufacturer: HIROSE [Hirose Electric]

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
No.
5
Shielding mesh
2
3
4
1
Ground clamp
Copper tape
Overlap of the copper tape
Overlap of the copper tape
Wires
Shielding clamp
Cable outer jacket
Copper tape
Cable outer jacket
Shielding mesh
Solder termination fixture
Illustration
Wires
1±0.5mm
Copper tape
Table 5
Shell size
LF07
LF10
LF13
5 to 6mm
Body / insulator assembly
E
Soldered joints
Copper tape
Shielding clamp
Cable outer jacket
Cable outer jacket
5mm max.
7mm max.
Commercially
available pliers
E
Note
Note
Note
Crimping of the Shielding Clamp
1
2
3
4
LF Series●Miniature Waterproof Shielded Connectors
After completion of the soldering operations
carefully remove (holding on the locking collar)
the body/insulator assembly from the solder
termination fixture.
Wrap the folded over shielding mesh with 5 to
6 mm wide copper tape to assure that it will
not become loose.
Apply the copper tape so that the shielding
mesh does not protrude from under it.
Insert the “U” shaped shielding clamp over the
copper tape as shown on the illustration.
It is critical that the overlap of the copper tape
is located inside the shielding clamp as shown
on the illustration.
Using commercially available pliers bend the
open ends of the shielding clamp as illustrated,
assuring that it stays in place. The dimension
of E. between opposing edges of the shielding
clamp is necessary to assure correct final
crimp.
Exercise caution not to damage or deform the
solder joints.
After wrapping the copper tape, the tape
should overlap itself by 2 mm max.
When the end of the copper tape wrapping is
positioned at the open side of the ground
fitting, the end portion of the copper tape
wrapping will no longer be covered by the
ground fitting when the ground fitting is
crimped.
Operation
9