ADL5562-EVALZ AD [Analog Devices], ADL5562-EVALZ Datasheet - Page 14

• Manufacturer Part Number: ADL5562-EVALZ
• Description: 3.3 GHz Ultralow Distortion RF/IF Differential Amplifier
• Manufacturer: AD [Analog Devices]

ADL5562
APPLICATIONS INFORMATION
BASIC CONNECTIONS
Figure 31 shows the basic connections for operating the ADL5562.
VCC should be 3.3 V with each supply pin decoupled with at least
one low inductance surface-mount ceramic capacitor of 0.1 μF
placed as close as possible to the device. The VCOM pin (Pin 9)
should also be decoupled using a 0.1 μF capacitor.
The gain of the part is determined by the pin-strappable input
configuration. When Input A is applied to VIP1 and Input B is
applied to VIN1, the gain is 6 dB (minimum gain, see Equation 1
and Equation 2). When Input A is applied to VIP2 and Input B
is applied to VIN2, the gain is 12 dB (middle gain). When
Input A is applied to VIP1 and VIP2 and Input B is applied to
VIN1 and VIN2, the gain is 15.5 dB (maximum gain).
BALANCED
SOURCE
R
R
S
S
/2
/2
0.1µF
0.1µF
A
B
Figure 31. Basic Connections
Rev. A | Page 14 of 24
1
2
3
4
VIP2
VIP1
VIN1
VIN2
10µF
ADL5562
Pin 1 to Pin 4, Pin 10, and Pin 11 are biased at 1/2 VCC above
ground and can be dc-coupled (if within the specified input or
output common-mode voltage levels) or ac-coupled as shown
in Figure 31.
To enable the ADL5562, the ENBL pin must be pulled high.
Pulling the ENBL pin low puts the ADL5562 in sleep mode,
reducing the current consumption to 3 mA at ambient.
0.1µF
VCOM
ENBL
VON
VOP
12
10
11
9
VCC
0.1µF
R
L
BALANCED
LOAD