ADL5571-EVALZ AD [Analog Devices], ADL5571-EVALZ Datasheet - Page 14

• Manufacturer Part Number: ADL5571-EVALZ
• Description: 2.5 GHz to 2.7 GHz WiMAX Power Amplifier
• Manufacturer: AD [Analog Devices]

ADL5571
MEASUREMENT SETUP
When using the ADL5571 evaluation board, the following set
up must be used:
1. Connect the output of the WiMAX signal generator to the RF
2. Connect the RF output SMA of the ADL5571 to the
3. Ensure that Jumper W1 is in place. Alternatively, use a
4. Connect power supply to VPOS. Set voltage to the desired
5. Connect another power supply to VREG. Set voltage to
6. Turn all voltage supplies on.
7. Turn RF source on.
input through a cable.
Spectrum Analyzer (preferably through an attenuator).
jumper cable to connect VPOS to VPOS1.
supply level (3.3 V, 5 V). Set the current limit on this
source to 1 A.
2.85 V. Set the current limit on this source to 100 mA.
Rev. 0 | Page 14 of 16
Table 7. Operating Modes: Power Supply
Nomenclature
VREG
STBY
1
Note that device is not sequence dependent.
2.85 V
2.5 V
High
1
Low
0 V
0 V