M27C800 STMICROELECTRONICS [STMicroelectronics], M27C800 Datasheet - Page 11

• Manufacturer Part Number: M27C800
• Description: 8 Mbit 1Mb x8 or 512Kb x16 UV EPROM and OTP EPROM
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

Electronic Signature
The Electronic Signature (ES) mode allows the
reading out of a binary code from an EPROM that
will identify its manufacturer and type. This mode
is intended for use by programming equipment to
automatically match the device to be programmed
with its corresponding programming algorithm.
The ES mode is functional in the 25°C ± 5°C am-
bient temperature range that is required when pro-
gramming the M27C800. To activate the ES
mode, the programming equipment must force
11.5V to 12.5V on address line A9 of the
M27C800, with V
bytes may then be sequenced from the device out-
puts by toggling address line A0 from V
other address lines must be held at V
Electronic Signature mode.
Byte 0 (A0 = V
code and byte 1 (A0 = V
code. For the STMicroelectronics M27C800, these
two identifier bytes are given in Table 4 and can be
read-out on outputs Q7 to Q0.
IL
PP
) represents the manufacturer
= V
CC
IH
) the device identifier
= 5V. Two identifier
IL
to V
IL
during
IH
. All
ERASURE OPERATION (applies to UV EPROM)
The erasure characteristics of the M27C800 is
such that erasure begins when the cells are ex-
posed to light with wavelengths shorter than ap-
proximately 4000 Å. It should be noted that
sunlight and some type of fluorescent lamps have
wavelengths in the 3000-4000 Å range. Research
shows that constant exposure to room level fluo-
rescent lighting could erase a typical M27C800 in
about 3 years, while it would take approximately 1
week to cause erasure when exposed to direct
sunlight. If the M27C800 is to be exposed to these
types of lighting conditions for extended periods of
time, it is suggested that opaque labels be put over
the M27C800 window to prevent unintentional era-
sure. The recommended erasure procedure for
M27C800 is exposure to short wave ultraviolet
light which has a wavelength of 2537 Å. The inte-
grated dose (i.e. UV intensity x exposure time) for
erasure should be a minimum of 30 W-sec/cm
The erasure time with this dosage is approximate-
ly 30 to 40 minutes using an ultraviolet lamp with
12000 µW/cm
should be placed within 2.5cm (1 inch) of the lamp
tubes during the erasure. Some lamps have a filter
on their tubes which should be removed before
erasure.
2
power rating. The M27C800
M27C800
11/18
2
.