XC68341CFT16 MOTOROLA [Motorola, Inc], XC68341CFT16 Datasheet - Page 14

• Manufacturer Part Number: XC68341CFT16
• Description: Integrated Processor Users Manual
• Manufacturer: MOTOROLA [Motorola, Inc]

51. Single Address Enable
6-33 SE-Single Address Enable: The note “used for intermodule DMA” should be for the SE=1 case. The
68341 does not support intermodule single address transfers, so the SE bit should always be programmed to
“0”.
52. Code Examples - Immediate Addressing Mode
On pages 6-40 through 6-44 make the following change as shown for each occurrence of SARADD, DARADD,
and NUMBYTE (change to immediate addressing mode for source operand):
53. Serial Oscillator Problems with DMA activity
Add to the Crystal Input or External Clock (X1) section on page 7-5: A high DREQ1 request rate (greater than
1MHz) with excessive undershoot on DREQ1 can result in internal signal coupling to the serial module oscil-
lator X1 pin, damping out oscillation. Avoid routing DREQ1 near the serial oscillator external components, and
use termination techniques such as series termination of the DREQ1 driver (start with 33 ) to limit edge rate
of the signal and accompanying undershoot.
54. Additional Note on RTSx operation details
Add to the RTSA and RTSB descriptions on page 7-6: The RTSx outputs are active low signals - they drive a
logic “0” when set, and a logic “1” when cleared.
RTSx can be set (output logic level 0) by any of the following:
RTSx can be cleared (output logic level 1) by any of the following:
55. Serial Frequency Restriction
On page 7-8, place the following notes at the end of Section 7.3.1 Baud Rate Generator:
The current implementation of the serial module restricts the minimum CLKOUT frequency at which the baud
rate generators can be used to approximately 8.3MHz. Operation below this frequency results in a synchro-
nized internal clock which is at a lower frequency than the X1 input, which then results in incorrect baud rates.
One method to extend the minimum CLKOUT frequency is to reduce the X1 frequency by powers of 2 as
shown in the table below. The corresponding baud rates selected by the clock select register programming are
MOTOROLA
MOVE.L SARADD,DMASAR1(A0) should be MOVE.L #SARADD,DMASAR1(A0).
MOVE.L DARADD,DMADAR1(A0) should be MOVE.L #DARADD,DMADAR1(A0).
MOVE.L NUMBYTE,DMABTC1(A0) should be MOVE.L #NUMBYTE,DMABTC1(A0).
• Writing a “1” to the corresponding bit in the OPSET register $71E
• Issuing an “Assert RTS” command using command register CR
• If RxRTS=1, set by receiver FIFO transition from FULL to not-FULL
• Hardware reset of the serial module
• Writing a “1” to the corresponding bit in the OPRESET register $71F
• Issuing a “Negate RTS” command using command register CR
• If RxRTS=1, cleared by receiver FIFO transition from not-FULL to FULL
• If TxRTS=1, cleared by completion of last character, including transmission of stop bits
MC68341 USER’S MANUAL ADDENDUM
13