AAT3152_05 ANALOGICTECH [Advanced Analogic Technologies], AAT3152_05 Datasheet - Page 10

• Manufacturer Part Number: AAT3152_05
• Description: High Efficiency 1X/1.5X/2X Charge Pump For White LED Applications
• Manufacturer: ANALOGICTECH [Advanced Analogic Technologies]

Auto-Disable Feature
The AAT3152 is equipped with an auto-disable fea-
ture for each LED channel. After the IC is enabled
and started up, a test current of 150µA (typical) is
forced through each sink channel. The channel will
be disabled if the voltage of that particular current
sink pin does not drop to a certain threshold. This
feature is very convenient for disabling an unused
channel (by tying the DX pin to V
LED fail short event.
Thermal Protection
The AAT3152 has a built-in thermal protection cir-
cuit that will shut down the charge pump if the die
temperature rises above the thermal limit, as is the
case during a short circuit of the V
Applications Information
LED Selection
Although the AAT3152 is specifically intended for
driving white LEDs, the device can also be used to
drive most types of LEDs with forward voltage
specifications ranging from 2.0V to 4.7V. LED
applications may include main and sub-LCD dis-
play backlighting, camera photo-flash applications,
color (RGB) LEDs, infrared (IR) diodes for remotes,
and other loads benefiting from a controlled output
S
10
2
Cwire Serial Interface Timing
Data Reg
EN/SET
1
OUT
OUT
2
) or during an
pin.
T
LO
n
1
T
HI
High Efficiency 1X/1.5X/2X Charge Pump
n <= 16
T
LAT
current generated from a varying input voltage.
Since the D1 to D4 input current sinks are matched
with negligible voltage dependence, the LED
brightness will be matched regardless of the spe-
cific LED forward voltage (V
instances (e.g., in high-luminous-output applica-
tions such as photo-flash), it may be necessary to
drive high-V
sinks in the AAT3152 make it capable of driving
LEDs with forward voltages as high as 4.7V at full
current from an input supply as low as 3.0V.
Outputs can be paralleled to drive high-current
LEDs without complication.
Device Switching Noise Performance
The AAT3152 operates at a fixed frequency of
approximately 1MHz to control noise and limit har-
monics that can interfere with the RF operation of
cellular telephone handsets or other communica-
tion devices. Back-injected noise appearing on the
input pin of the charge pump is 20mV peak-to-
peak, typically ten times less than inductor-based
DC/DC boost converter white LED backlight solu-
tions. The AAT3152 soft-start feature prevents
noise transient effects associated with in-rush cur-
rents during start-up of the charge pump circuit.
Capacitor Selection
Careful selection of the four external capacitors
C
affect turn-on time, output ripple, and transient per-
IN
, C
1
, C
For White LED Applications
2
, and C
F
type LEDs. The low-dropout current
n
OUT
T
OFF
is important because they will
F
0
) levels. In some
AAT3152
3152.2005.08.1.2