ADG658 Analog Devices, ADG658 Datasheet - Page 6

• Manufacturer Part Number: ADG658
• Description: +3 V/+5 V/5 V CMOS 4-/8-Channel Analog Multiplexers
• Manufacturer: Analog Devices

Parameter
V
V
I
I
GND
S
D
A
EN
V
R
R
R
R
R
I
I
I
V
V
I
C
C
C
C
t
t
t
Charge Injection
Charge Injection
Off Isolation
Crosstalk
Bandwidth
On Response
Insertion Loss
ADG658/ADG659
DD
SS
S
D
D
INL
ON
OFF
BBM
DD
SS
X
D
ON
FLAT(ON)
FLAT(ON)
INL
INH
S
D
D
IN
, I
(OFF)
(OFF)
(OFF)
, C
ON
(V
(OFF)
(I
S
INH
(ON)
S
S
)
(ON)
)
Description
Most Positive Power Supply Potential.
Most Negative Power Supply Potential.
Positive Supply Current.
Negative Supply Current.
Ground (0 V) Reference.
Source Terminal. May be an input or output.
Drain Terminal. May be an input or output.
Logic Control Input.
Active Low Digital Input. When high, device is disabled and all switches are OFF. When low, A
determine ON switch.
Analog Voltage on Terminals D, S.
Ohmic Resistance between D and S.
On Resistance Match between Any Two Channels, i.e., R
Flatness is defined as the difference between the maximum and minimum value of ON Resistance as
measured over the specified analog signal range.
Source Leakage Current with the Switch OFF.
Drain Leakage Current with the Switch OFF.
Channel Leakage Current with the Switch ON.
Maximum Input Voltage for Logic 0.
Minimum Input Voltage for Logic 1.
Input Current of the Digital Input.
OFF Switch Source Capacitance. Measured with reference to ground.
OFF Switch Drain Capacitance. Measured with reference to ground.
ON Switch Capacitance. Measured with reference to ground.
Digital Input Capacitance.
Delay between Applying the Digital Control Input and the Output Switching ON. See Test Circuit 7.
Delay between Applying the Digital Control Input and the Output Switching OFF.
ON Time. Measured between 80% points of both switches when switching from one address state to another.
Measure of the Glitch Impulse Transferred from the Digital Input to the Analog Output during Switching.
Measure of Unwanted Signal Coupling through an OFF Switch.
Measure of Unwanted Signal Coupled through from One Channel to Another as a Result of Parasitic Capacitance.
The Frequency at which the Output is Attenuated by 3 dB.
The Frequency Response of the ON Switch.
The Loss Due to the ON Resistance of the Switch.
TERMINOLOGY
–6–
ON
max – R
ON
min.
X
logic inputs
REV. 0