EVAL-AD1959EB AD [Analog Devices], EVAL-AD1959EB Datasheet - Page 7

• Manufacturer Part Number: EVAL-AD1959EB
• Description: PLL/Multibit DAC
• Manufacturer: AD [Analog Devices]

POWER SUPPLY AND VOLTAGE REFERENCE
The AD1959 is designed for five-volt supplies. Separate power
supply pins are provided for the analog, digital, and PLL sec-
tions. These pins should be bypassed with 100 nF ceramic chip
capacitors, as close to the pins as possible, to minimize noise. A
bulk aluminum electrolytic capacitor of at least 22 µF should
also be provided on the same PC board. For best performance it
is recommended that the analog supply be separate from the
digital and PLL supply. It is recommended that all supplies be
isolated by ferrite beads in series with each supply. It is expected
that the digital and PLL sections will be run from a common
supply but isolated from one another. It is important that the
analog supply be as clean as possible.
The internal voltage reference is brought out on Pin 21 (FILTR)
and should be bypassed as close as possible to the chip with a
LRCLK
SDATA
LRCLK
SDATA
LRCLK
SDATA
LRCLK
SDATA
BCLK
BCLK
BCLK
BCLK
NOTES
1. DSP MODE DOES NOT IDENTIFY CHANNEL.
2. LRCLK NORMALLY OPERATES AT f
3. BCLK FREQUENCY IS NORMALLY 64
MSB
MSB
MSB
MSB
LEFT CHANNEL
LEFT CHANNEL
LEFT CHANNEL
S
RIGHT-JUSTIFIED MODE – SELECT NUMBER OF BITS PER CHANNEL
EXCEPT FOR DSP MODE WHICH IS 2
LRCLK BUT MAY BE OPERATED IN BURST MODE.
LEFT-JUSTIFIED MODE – 16 TO 24 BITS PER CHANNEL
LSB
DSP MODE – 16 TO 24 BITS PER CHANNEL
1
2
S MODE – 16 TO 24 BITS PER CHANNEL
LSB
LSB
LSB
1/f
S
parallel combination of 10 µF and 100 nF The reference voltage
may be used to bias external op amps to the common-mode
voltage of the analog output signal pins. The current drawn
from the V
SERIAL DATA PORTS – DATA FORMAT
The DAC serial data input mode defaults to I
Bits 4 and 5 in the DAC control register, the mode can be
changed to RJ, DSP, or LJ. The word width defaults to 24 bits
but can be changed by programming Bits 8 and 9 in the DAC
Control Register.
Figure 2 shows the serial mode formats.
MSB
f
S
.
MSB
MSB
REF
pin should be limited to less than 50 µA.
MSB
RIGHT CHANNEL
RIGHT CHANNEL
RIGHT CHANNEL
LSB
LSB
LSB
2
S. By changing
AD1959
LSB