AK4129 AKM [Asahi Kasei Microsystems], AK4129 Datasheet - Page 38

• Manufacturer Part Number: AK4129
• Description: 6ch 216kHz / 24-Bit Asynchronous SRC
• Manufacturer: AKM [Asahi Kasei Microsystems]

■
The AK4129 supports fast-mode I
connected to (DVDD1-4 + 0.3)V or less voltage.
1. Data transfer
All commands are preceded by a START condition. After the START condition, a slave address is sent. After the AK4129
recognizes the START condition, the device interfaced to the bus waits of the slave address to be transmitted over the SDA
line. If the transmitted slave address matches an address for one of the devices, the designated slave device pulls the SDA
line to LOW (ACKNOWLEDGE). The data transfer is always terminated by a STOP condition generated by the master
device.
1-1. Data validity
The data on the SDA line must be stable during a HIGH period of the clock. The HIGH or LOW state of the data line can
only be changed when the clock signal on the SCL line is LOW except for the START and the STOP condition.
1-2. START and STOP condition
A HIGH to LOW transition on the SDA line while SCL is HIGH indicates a START condition. All sequences start from the
START condition.
A LOW to HIGH transition on the SDA line while SCL is HIGH defines a STOP condition. All sequences end by the
STOP condition.
S
MS1173-E-01
Serial Control Interface
SCL
SDA
SCL
SDA
START CONDITION
2
C-bus system (max: 400kHz). Pull-up resistors at SDA and SCL pins should be
Figure 40. START and STOP conditions
DATA VALID
DATA LINE
STABLE :
Figure 39. Data Transfer
- 38 -
CHANGE
OF DATA
ALLOWED
STOP CONDITION
[AK4129]
2010/09