MT91L60AS MITEL [Mitel Networks Corporation], MT91L60AS Datasheet - Page 13

• Manufacturer Part Number: MT91L60AS
• Description: ISO2-CMOS 3 Volt Multi-Featured Codec (MFC)
• Manufacturer: MITEL [Mitel Networks Corporation]

Advance Information
Note: Bits marked "-" are reserved bits and should be written with logic "0"
Path Control
Control Register 1
DrGain
PDFDI
PDDR
Rst
TxMute
RxMute
TxBsel
RxBsel
PDFDI PDDR
-
When high, the receiver driver gain is set to -6 dB, with sidetone.
When low, the receiver driver gain is set to 0 dB, with no sidetone.
When high the received PCM stream is interrupted and replaced with quiet code; thus forcing the receive path into a
When high, the FDI PLA and the Filter/Codec are powered down (default). When low, the FDI is active.
When high, the ear driver and Filter/Codec are powered down A (default). In addition, in ST-BUS mode, the selected
When high, the transmit B2 channel is functional in ST-BUS mode. When low, the transmit B1 channel is functional in
When high, the receive B2 channel is functional in ST-BUS mode. When low, the receive B1 channel is functional in
When high, a software reset occurs performing the same function as the hardware reset (PWRST) except that the
When high the transmit PCM stream is interrupted and replaced with quiet code; thus forcing the output code into a
output channel is tri-stated. In SSI mode the PCM output code will be -zero code during the valid strobe period. The
output will be tri-stated outside of the valid strobe and for the whole frame if no strobe is supplied. When low, the driver
and Filter/Codec are active if PDFDI is low.
microport is not affected. A software reset can be removed only by writing this bit low or by a PWRST. When low, the
reset condition is removed.
mute state (only the output code is muted, the transmit microphone and transmit Filter/Codec are still functional). When
low the full transmit path functions normally (default).
mute state. When low the full receive path functions normally (default).
ST-BUS mode. Not used in SSI mode.
ST-BUS mode. Not used in SSI mode.
7
7
-
6
6
Rst
-
5
5
-
_
4
4
TxMute RxMute
-
3
3
-
2
2
TxBsel RxBsel
1
1
-
DrGain
ADDRESS = 02h WRITE/READ VERIFY
ADDRESS = 03h WRITE/READ VERIFY
0
0
Power Reset Value
Power Reset Value
XX00 0000
1100 0000
MT91L60
7-119