ACX301AKM SONY [Sony Corporation], ACX301AKM Datasheet - Page 25

• Manufacturer Part Number: ACX301AKM
• Description: 5.1cm (2.0 Type) NTSC/PAL Color LCD Panel (Module with Backlight)
• Manufacturer: SONY [Sony Corporation]

Notes on Handling
(1) Static charge prevention
(2) Protection from dust and dirt
(3) Module fixing method
(4) Other handling precautions
Be sure to take the following protective measures. TFT-LCD panels are easily damaged by static charges.
a) Use non-chargeable gloves, or simply use bare hands.
b) Use an earth-band when handling.
c) Do not touch any electrodes of a panel.
d) Wear non-chargeable clothes and conductive shoes.
e) Install grounded conductive mats on the working floor and working table.
f) Keep panels away from any charged materials.
g) Use ionized air to discharge the panels.
a) Operate in a clean environment.
b) When delivered, the panel surface (Polarizer) is covered by a protective sheet. Peel off the protective
c) Do not touch the polarizer surface. The surface is easily scratched. When cleaning, use a clean-room
d) Use ionized air to blow dust off the panel.
a) The design reference edges are the upper and left edges as viewed from the front. (See the Package
b) Positioning in the x and y directions should be based on the panel frame or the panel window frame.
c) Do not set positioning guides inside the following ranges.
d) Set the backlight holder on the rear of the backlight outside of the effective area of the panel. In
e) Connect the panel or backlight frame to GND. (static charge prevention)
f) High voltage is applied around the CCFL, so avoid locating metal objects within 1mm from the side of
a) Do not twist or bend the flexible PC board especially at the connecting region because the board is
b) Do not fold or pull on the backlight harness.
c) Do not drop the panel.
d) Do not twist or bend the panel, panel frame or backlight.
e) Keep the panel and backlight away from heat sources.
f) Do not dampen the panel or backlight with water or other solvents.
g) Avoid storage or use the panel at high temperatures or high humidity, as this may result in damage
sheet carefully so as not to damage the panel.
wiper with isopropyl alcohol. Be careful not to leave stains on the surface.
Outline.)
c-1: Within 2.3mm on both sides of the four panel frame corners
c-2: FPC outlet portion
c-3: Back light lamp socket portion
particular, use a structure that does not apply pressure near the center of the rear of the backlight.
the lamp socket (rubber) in order to prevent discharge. (See the figure below.)
easily deformed.
(faulty backlight lighting).
(High voltage side)
Metal object prohibited area
(lamp socket side)
1.0
– 25 –
ACX301AKM