MAAMSS0045TR-3000 MA-COM [M/A-COM Technology Solutions, Inc.], MAAMSS0045TR-3000 Datasheet - Page 4

• Manufacturer Part Number: MAAMSS0045TR-3000
• Description: High Dynamic Range Low Noise Amplifier 1400 - 2000 MHz
• Manufacturer: MA-COM [M/A-COM Technology Solutions, Inc.]

4
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.
Commitment to produce in volume is not guaranteed.
High Dynamic Range Low Noise Amplifier
1400 - 2000 MHz
Recommended PCB Configuration
MAAMSS0045 Evaluation Board
MAAMSS0045
Designer’s Kit MAAMSS0045SMB
Layout View
The MAAMSS0045SMB Designer’s Kit allows for immediate evaluation of M/A-COM’s MAAMSS0045. The
Designer’s Kit includes an MAAMSS0045 mounted on an evaluation board and five loose MAAMSS0045’s. The
evaluation board consists of the recommended external surface mount circuitry, RF connectors, and a DC
multi-pin connector, all mounted to a multi-layer FR-4 PCB.
illustrated below with all functional ports labeled.
M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
changes to the product(s) or information contained herein without notice.
Cross Section View
Evaluation PCB & RF Connector Losses
The DC connector on the Designer’s Kit PCB allows convenient
DC line access. This is accomplished by the one or more of the
following methods.
1.
2.
3.
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
The PCB dielectric between RF traces and RF ground
layers should be chosen to reduce RF discontinuities
between 50 Ω lines and package pins.
recommends
of .008”
0.015” (0.38 mm). The recommended RF metalization
is 1 ounce copper.
Visit www.macomtech.com for additional data sheets and product information.
A mating female multi-pin connector (Newark Electronics
Stock # 46F-4658, not included).
Wires soldered to the necessary pins (not included).
Clip leads (not included).
Port Reference
The MAAMSS0045SMB evaluation PCB is
RF Out
RF In
(0.20 mm) yielding a 50 Ω lines width of
an
FR-4
Approximate RF Loss
0.15 dB @ 1785 MHz
0.15 dB @ 1785 MHz
dielectric
thickness
M/A-COM
Rev. V1