JSH-85L3AB1-10 JDSU [JDS Uniphase Corporation], JSH-85L3AB1-10 Datasheet - Page 20

• Manufacturer Part Number: JSH-85L3AB1-10
• Description: 8.5 G Fibre Channel Compliant SFP+ 1310 nm Limiting Transceiver
• Manufacturer: JDSU [JDS Uniphase Corporation]

20
Memory Address
101
102
103
104
105
106
107
108
109
110-7
110-6
110-5
110-4
110-3
110-2
110-1
110-0
111
112-119
120-127
128-247
248-255
Note :
1. During Tx disable, Tx bias and Tx power will not be monitored.
2. Alarm and warning are latched. The flag registers are cleared when the system Reads AND the alarm/warning condition no longer exists.
Diagnostics Data Map
value
TX Bias LSB (Note 1)
TX Power MSB (Note 1)
TX Power LSB (Note 1)
RX Power MSB
RX Power LSB
Reserved MSB
Reserved LSB
Reserved MSB
Reserved LSB
Tx Disable State
Soft Tx Disable Control
Reserved
Rate Select State
Soft Rate Select Control
Tx Fault State
LOS State
Data Ready State
Reserved
Optional alarm & warning flag bits (Note 2)
Vendor specific
User/Customer EEPROM
Vendor specific
(continued)
8.5 G FIBRE CHANNEL COMPLIANT SFP+
1310 NM LIMITING TRANSCEIvER
Comments
Measured TX output power AD values
Measured RX input power AD values
For 1st future definition of digitized analog input
For 2nd future definition of digitized analog input
Digital State of Tx_Disable Pin
Writing “1” OR pulling the Tx_Disable pin will disable
the laser
Digital State of Rate Select Pin
Writing to this bit has no effect
Digital State of Tx_Fault Pin
Digital State of Rx LOS Pin
Digital State; “1” until transceiver is ready
Reserved
Refer to SFF-8472 Revision 10.3
JDSU specific
Field writeable EEPROM
Vendor-specific control