JXP-01EEAB1 JDSU [JDS Uniphase Corporation], JXP-01EEAB1 Datasheet - Page 15

• Manufacturer Part Number: JXP-01EEAB1
• Description: Multiprotocol XFP Optical Transceiver-1550 nm for up to 40 km Reach
• Manufacturer: JDSU [JDS Uniphase Corporation]

15
Section 4
Other information related to the JDSU 10 Gbps 1550 nm multiprotocol XFP
optical transceiver includes:
• Section 4.1 Packing and Handling Instructions
• Section 4.2 ESD Discharge (ESD)
• Section 4.3 Eye Safety
4.1 Package and Handling Instructions
Connector covers
The JDSU 10 Gbps 1550 nm multiprotocol XFP optical transceiver is supplied
with an LC duplex receptacle. The connector plug supplied protects the connector
during standard manufacturing processes and handling by preventing contamina-
tion from dust, aqueous solutions, body oils, or airborne particles.
Note: It is recommended that the connector plug remain on whenever the trans-
ceiver optical fiber connector is not inserted.
Recommended cleaning and degreasing chemicals
JDSU recommends the use of methyl, isopropyl and isobutyl alcohols for cleaning.
Do not use halogenated hydrocarbons (e.g. trichloroethane, ketones such as ac-
etone, chloroform, ethyl acetate, MEK, methylene chloride, methylene dichloride,
phenol, N-methylpyrolldone).
This product is not designed for aqueous wash.
Housing
The JDSU 10 Gbps 1550 nm multiprotocol XFP optical transceiver housing is made
from zinc.
4.2 ESD Discharge (ESD)
Handling
Normal ESD precautions are required during the handling of this module. This
transceiver is shipped in ESD protective packaging. It should be removed from
the packaging and otherwise handled in an ESD protected environment utilizing
standard grounded benches, floor mats, and wrist straps.
Test and operation
In most applications, the optical connector will protrude through the system chas-
sis and be subjected to the same ESD environment as the system. Once properly
installed in the system, this transceiver should meet and exceed common ESD test-
ing practices and fulfill system ESD requirements.
Typical of optical transceivers, this module’s receiver contains a highly sensitive
optical detector and amplifier which may become temporarily saturated during
an ESD strike. This could result in a short burst of bit errors. Such an event might
require that the application re-acquire synchronization at the higher layers (e.g.
Serializer / Deserializer chip).
MUlTIPROTOCOl XFP OPTICAl TRANSCEIvER
—1550 NM FOR UP TO 40 KM REACH
Related Information