DF20A-10DP-1H HIROSE [Hirose Electric], DF20A-10DP-1H Datasheet - Page 7

• Manufacturer Part Number: DF20A-10DP-1H
• Description: 1 mm Pitch Double Rows Low Profile Board-to-Cable Connectors
• Manufacturer: HIROSE [Hirose Electric]

BUsage recommendation
1. Recommended Soldering
2.Recommended Manual Soldering Conditions
3. Recommended Solder Screen Thickness
4. Board Warping
5. Cleaning Conditions
6. Wiring Termination Conditions
7. Mating / un-mating precautions
Temperature Profile for IR Reflow.
Note 1: Up to 2 cycles of reflow soldering are possible under the same conditions, provided
Note 2: The temperature indicates the board surface temperature at the points of contacts
Soldering temperature: 290°C ±10°C, Soldering time: within 3 sec.
0.15mm
Maximum of 0.03 mm at the connector center section, with both ends of the connector as reference points.
Refer to "Nylon Connector Use Handbook."
Refer to "Nylon Connector Use Handbook."
Crimp contacts should be handled with care as not to cause any deformation or damage
affecting the performance or termination.
Excessive twisting and pulling on wires during mating/un-mating should be avoided as it
may cause damage to connectors.
that there is a return to normal temperature between the first and second cycle.
with the connector terminals.
7