MSM6665C-XX OKI [OKI electronic componets], MSM6665C-XX Datasheet - Page 18

• Manufacturer Part Number: MSM6665C-XX
• Description: DOT MATRIX LCD CONTROLLER WITH 17-DOT COMMON DRIVER AND 80-DOT SEGMENT DRIVER
• Manufacturer: OKI [OKI electronic componets]

¡ Semiconductor
*1
Flowchart for Power-On Timing
NO
After the required commands and display data are intered, perform busy detection
based on the SO pin status. When it is confirmed that the status has been changed
from BUSY (SO="L") to NON-BUSY (SO="H"), enter the next data.
If busy detection is not performed, wait for 10 master oscillation clocks when used at
1/17 duty or for 20 master oscillation clocks when at 1/9 duty, then enter the next
data.
Input display data for initial screen
AINC executed 48 times
Is Input of display data for
initial screen completed?
Wait for 20 clocks
Wait for 20 clocks
LOT, I1="1", I0="1"
LOT, I1="1", I0="1"
Normal operation
BPC and BKCG
Turn on power
SOE/D, D0="1"
command set
DISP, D0="1"
Reset input
CS="H"
YES
5ms required; external reset input or power-on reset input
Clock input for initial busy clear.
The device is enabled.
Make the SO output enable, to perform busy detection.
Input a wait for the SOE/D command processing. (For the processing
of each command after this, perform busy detection. *1)
Set the blink pattern and bank change mode.
Set the Load Option. (Blank-code writing and blink-cancellation
are executed each time the AINC command is executed.)
Input the AINC command to clear the RAM data.
Release the Load Option.
Display is turned on and the initial screen is displayed.
(
10 clocks at 1/17 duty
20 clocks at 1/9 duty
FEDL6665C-02
MSM6665C-xx
)
18/31