MP1523DT MPS [Monolithic Power Systems], MP1523DT Datasheet - Page 4

• Manufacturer Part Number: MP1523DT
• Description: 6 White LEDs, 20mA Precision WLED Driver Evaluation Board
• Manufacturer: MPS [Monolithic Power Systems]

QUICK START GUIDE
1. Solder LED1 – LED6 onto the board.
2. Connect VCC to the power source’s positive output.
3. Connect GND to supply ground.
4. Remove the jumper J1 to allow the MP1523 to automatically start when power is applied. Place the
5. To dim the LEDs, remove the shorting clip from J1 and apply a PWM signal to the EN pin. Adjusting
NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.
Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS
products into any application. MPS will not assume any legal responsibility for any said applications.
EV0035 Rev. 1.2
3/30/2006
shorting clip across J1 to disable the MP1523. A logic signal may be applied to EN to
enable/disable the MP1523, provided the shorting clip is not installed across J1.
the duty cycle of the PWM signal determines the brightness of the LEDs.
TM
EV0035 – 6 WHITE LEDs, 20mA PRECISION WLED DRIVER EVALUATION BOARD
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2006 MPS. All Rights Reserved.
www.MonolithicPower.com
4