MT18KDF51272AZ-1G4M1 Micron, MT18KDF51272AZ-1G4M1 Datasheet - Page 16

• Manufacturer Part Number: MT18KDF51272AZ-1G4M1
• Description: Module Ddr3 Sdram 4gb 240udimm
• Manufacturer: Micron

EVENT# Pin
PDF: 09005aef8480d687
kdf18c512x72az.pdf – Rev. A 9/11 EN
The temperature sensor also adds the EVENT# pin (open-drain). Not used by the SPD
EEPROM, EVENT# is a temperature sensor output used to flag critical events that can be
set up in the sensor’s configuration register.
EVENT# has three defined modes of operation: interrupt mode, compare mode, and
critical temperature mode. Event thresholds are programmed in the 0x01 register using
a hysteresis. The alarm window provides a comparison window, with upper and lower
limits set in the alarm upper boundary register and the alarm lower boundary register,
respectively. When the alarm window is enabled, EVENT# will trigger whenever the
temperature is outside the MIN or MAX values set by the user.
The interrupt mode enables software to reset EVENT# after a critical temperature
threshold has been detected. Threshold points are set in the configuration register by
the user. This mode triggers the critical temperature limit and both the MIN and MAX of
the temperature window.
The compare mode is similar to the interrupt mode, except EVENT# cannot be reset by
the user and returns to the logic HIGH state only when the temperature falls below the
programmed thresholds.
Critical temperature mode triggers EVENT# only when the temperature has exceeded
the programmed critical trip point. When the critical trip point has been reached, the
temperature sensor goes into comparator mode, and the critical EVENT# cannot be
cleared through software.
Temperature Sensor with Serial Presence-Detect EEPROM
4GB(x72, ECC, DR) 240-Pin 1.35V DDR3L VLP UDIMM
16
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2011 Micron Technology, Inc. All rights reserved.