SPBT2632C1A.AT2 STMicroelectronics, SPBT2632C1A.AT2 Datasheet - Page 22

• Manufacturer Part Number: SPBT2632C1A.AT2
• Description: Bluetooth / 802.15.1 Modules Bluetooth Class1 MOD v3.0 RF 128bit 60m
• Manufacturer: STMicroelectronics

Specifications of SPBT2632C1A.AT2

• Rohs: yes
• Class: 1
• Frequency Band: 2.4 GHz
• Sensitivity: - 90 dBm
• Data Rate: 1.5 Mbps
• Operating Supply Voltage: 2 V to 3.6 V
• Interface Type: I2C, SPI, UART
• Antenna Connector Type: Integrated
• Maximum Operating Temperature: + 85 C
• Dimensions: 15 mm x 27 mm x 2.9 mm

Regulatory compliance
8
22/26
Regulatory compliance
●
●
FCC and IC
–
–
–
The label should use wording such as the following:
Contains transmitter module
FCC ID: X3ZBTMOD3
IC: 8828A-MOD3
Any similar wording that expresses the same meaning may be used.
BQB
– BQB qualified design, QD ID: B019224
– Product type: End Product
– TGP version: Core 3.0
– Core spec version: 3.0
– Product descriptions: Bluetooth module, spec V3.0
This module has been tested and found to comply with the FCC part 15 and IC
RSS-210 rules. These limits are designed to provide reasonable protection
against harmful interference in approved installations. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference may not occur
in a particular installation. This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Modifications or changes to this equipment not expressly approved by the part
responsible for compliance may render void the user’s authority to operate this
equipment.
Modular Approval, FCC and IC
FCC ID: X3ZBTMOD3
IC: 8828A-MOD3
In accordance with FCC part 15, the SPT2632C1A.AT2 is listed above as a
modular transmitter device.
Label instructions:
When integrating the SPBT2632C1A.AT2 into the final product, it must be
ensured that the FCC labelling requirements, as specified below, are satisfied.
Based on the public notice from FCC, the product into which the ST transmitter
module is installed must display a label referring to the enclosed module.
Doc ID 022930 Rev 3
SPBT2632C1A