RN21-I/RM Roving Networks, RN21-I/RM Datasheet - Page 5

no-image

RN21-I/RM

Manufacturer Part Number
RN21-I/RM
Description
Bluetooth / 802.15.1 Modules Class1 Bluetooth Mod v2.0+EDR, No Antenna
Manufacturer
Roving Networks
Datasheet

Specifications of RN21-I/RM

Product Category
Bluetooth / 802.15.1 Modules
Rohs
yes
Frequency Band
2.4 GHz
Data Rate
921.6 Kbps
Operating Supply Voltage
3.3 VDC
Interface Type
PCM, UART, USB
Antenna Connector Type
Chip
Maximum Operating Temperature
+ 85 C
Dimensions
21.8 mm x 12.5 mm x 2 mm
Minimum Operating Temperature
- 40 C
Modulation Technique
FHSS
Factory Pack Quantity
30

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
RN21-I/RM
Manufacturer:
MICROCHIP
Quantity:
12 000
Module Dimensions
Design Concerns
0.8 mm (pad)
1. Reset circuit. RN-21 contains a 1k pull-down to GND, the polarity of reset is active HIGH.
2. Factory reset PIO4. It is a good idea to connect this pin to a switch, or jumper, or resistor, so it can be
3. Connection status. PIO5 is available to drive an LED, and blinks at various speeds to indicate status.
4. HCI mode. The RN21 module must be loaded with special firmware to run in HCI mode. When in HCI
1.27 mm
A power on reset circuit with delay is OPTIONAL on the reset pin of the module. It should only be required
if the input power supply has a very slow ramp, or tends to bounce or have instability on power up.
a microcontroller or embedded CPU IO is available to generate reset once power is stable. If not, there
are many low cost power supervisor chips available, such as MCP8010.
accessed. This pin can be used to reset the module to FACTORY DEFAULTS and is often critical in
situations where the module has been misconfigured.
PIO2 is an output which directly reflects the connection state, it goes HIGH when connected, and LOW
otherwise.
mode the standard SPP/DUN profiles are disabled.
809 University Avenue
PCB LAYOUT
9.87 mm
0.94 mm (pad)
1.27 mm
RN21
15.0 mm
Los Gatos, CA 95032
0.75 mm
0.75 mm
1.32 mm
0.68 mm (pad)
21.82 mm
Tel (408) 395-6539
1.85 mm
1.85 mm
• info@RovingNetworks.com
DS-RN21-V2 3/25/2010
RN21
RN21
MODULE DIMENSIONS
15.4 mm
15.4 mm
22.0 mm
22.0 mm
22.0 mm
22.0 mm
Often

Related parts for RN21-I/RM