450-0104C LS Research, 450-0104C Datasheet - Page 17
![no-image](/images/no-image-200.jpg)
450-0104C
Manufacturer Part Number
450-0104C
Description
Bluetooth / 802.15.1 Modules TiWi-uB2 Mod,CutTape BT 2.1+ EDR, BLE 4.0
Manufacturer
LS Research
Datasheet
1.450-0104.pdf
(30 pages)
Specifications of 450-0104C
Rohs
yes
CLEANING
In general, cleaning the populated modules is
strongly discouraged. Residuals under the
module cannot be easily removed with any
cleaning process.
OPTICAL INSPECTION
After soldering the Module to the host board,
consider optical inspection to check the
following:
REWORK
The module can be unsoldered from the host
board if the Moisture Sensitivity Level (MSL)
requirements are met as described in this
datasheet.
The information in this document is subject to change without notice.
330-0100-R1.0
Never attempt a rework on the
module itself, e.g. replacing
individual components. Such actions
will terminate warranty coverage.
Cleaning with water can lead to capillary
effects where water is absorbed into the gap
between the host board and the module.
The combination of soldering flux residuals
and encapsulated water could lead to short
circuits between neighboring pads. Water
could also damage any stickers or labels.
Cleaning with alcohol or a similar organic
solvent will likely flood soldering flux
residuals into the RF shield, which is not
accessible for post-washing inspection. The
solvent could also damage any stickers or
labels.
Ultrasonic cleaning could damage the
module permanently.
Proper alignment and centering of the
module over the pads.
Proper solder joints on all pads.
Excessive solder or contacts to neighboring
pads, or vias.
Copyright © 2012-2013 LS Research, LLC
SHIPPING, HANDLING, AND STORAGE
Shipping
Bulk orders of the TiWi-uB2 modules are
delivered in trays of 416 (13 x 32) or reels of
2,000.
Handling
The TiWi-uB2 modules contain a highly
sensitive electronic circuitry. Handling without
proper ESD protection may damage the module
permanently.
Moisture Sensitivity Level (MSL)
Per J-STD-020, devices rated as MSL 4 and
not stored in a sealed bag with desiccant pack
should be baked prior to use.
After opening packaging, devices that will be
subjected to reflow must be mounted within 72
hours of factory conditions (<30°C and 60%
RH) or stored at <10% RH.
Bake devices for 48 hours at 125°C.
Storage
Please use this product within 6 months after
receipt. Any product used after 6 months of
receipt needs to have solderability confirmed
before use.
The product shall be stored without opening the
packing under the ambient temperature from 5 to
35deg.C and humidity from 20 to 70%RH.
(Packing materials, in particular, may be
deformed at the temperatures above this range.)
Do not store in salty air or in an environment
with a high concentration of corrosive gas, such
as Cl2, H2S, NH3, SO2, or NOX.
Do not store in direct sunlight.
The product should not be subject to excessive
mechanical shock.
DATASHEET
TiWi-uB2 Module
Page 17 of 30