EP2600TS-40.000M Ecliptek, EP2600TS-40.000M Datasheet - Page 3

• Manufacturer Part Number: EP2600TS-40.000M
• Description: Programmable Oscillators 40MHz 100ppm -20C +70C
• Manufacturer: Ecliptek

Specifications of EP2600TS-40.000M

• Product Category: Programmable Oscillators
• Rohs: yes

10.
11.
If the tri-state (TS) option is selected, the output is three-stated (tri-state) when the voltage at the control pad
(pad one) is set to a logic low state. In this condition, the internal oscillator circuit continues to operate. However,
the output signal is now high impedance and the input current on the power supply line is only slightly decreased
from normal operating current. The disable current specification can be found on the data sheet.
Note: The oscillator has an internal pull up resistor on the control pad. The series datasheet provides the V
V
When entering the tri-state or power down modes, the time from when the oscillator pad one input control reaches
V
time from when the oscillator pad one input control reaches V
as t
Can I obtain a non-tri-state function for this product series?
This product series only offers tri-state or power down options on pad one of the oscillator. The customer can use
this oscillator series as a non-tri-state oscillator by setting the voltage on tri-state control (pad one) to either no
connect or logic high. The oscillator has an internal pull up resistor on tri-state control (pad one). The datasheet
provides the V
How do I specify the overall frequency stability for this product series?
Ecliptek defines the frequency stability performance of the device inclusive of specific oscillator operating
conditions. This is often called the "Inclusive Method". Ecliptek specifies the following parameters for this series of
product:
EP26 TEN10-005-097 Rev A
IL
IL
thresholds for control of the power down and tri-state functions.
and the oscillator output pad becomes high impedance is shown as t
PZL
.
Calibration Frequency Tolerance at 25°C
Frequency Stability over Operating Temperature Range
Supply Voltage
Output Load
First Year Aging at 25°C
IH
and V
IL
thresholds for control of the tri-state function.
Figure: Tri-State Timing Diagram
OH
and the oscillator output begins clocking is shown
Ecliptek Frequently Asked Questions
PLZ
. When exiting the tri-state mode, the
Page 3 of 6
IH
and