MAX1464AAI-T Maxim Integrated, MAX1464AAI-T Datasheet - Page 30

• Manufacturer Part Number: MAX1464AAI-T
• Description: Digital Signal Processors & Controllers - DSP, DSC Low-Pwr/Nse MultiCh Sensor Signal Prcssr
• Manufacturer: Maxim Integrated
• Series: MAX1464r

Specifications of MAX1464AAI-T

• Data Bus Width: 16 bit
• Program Memory Size: 4 KB, 128 B
• Maximum Clock Frequency: 5.3 MHz
• Number Of Programmable I/os: 2
• Operating Supply Voltage: 5 V
• Interface Type: SPI
• On-chip Adc: Yes
• Processor Series: MAX1464
• Product: DSPs
• Program Memory Type: Flash

Low-Power, Low-Noise Multichannel
Sensor Signal Processor
Table 5. ADC_Control (Address = 00h)
Table 6. Initiate Conversion (CNVT1, CNVT2, CNVTT)
*The value bbbb is any nonzero single-ended setting.
30
CNVT1
15–12
BITS
11–8
0
0
0
1
0
0
1
7–3
______________________________________________________________________________________
2
1
0
CNVT2
0
0
1
X
0
1
X
SE[3:0]
CNVT1
CNVT2
CNVTT
NAME
—
—
CNVTT
X
X
X
X
0
1
1
Unused.
Single-ended signal source multiplexer. SE[3] = MSB.
Unused.
1 = Initiate conversion on channel 1 using ADC settings specified in registers ADC_Config_1A and
ADC_Config_1B. The ADC result is stored in ADC_Data_1. CPU is halted during the conversion
process. This bit is automatically reset to zero when conversion is completed.
1 = Initiate conversion on channel 2 using ADC settings specified in registers ADC_Config_2A and
ADC_Config_2B. The ADC result is stored in ADC_Data_2. CPU is halted during the conversion
process. This bit is automatically reset to zero when conversion is completed.
1 = Initiate conversion on temperature sensor using ADC settings specified in registers
ADC_Config_TA and ADC_Config_TB. The ADC result is stored in ADC_Data_T. CPU is halted during
the conversion process. The bit is automatically reset to zero when conversion is completed.
SE[3:0]
bbbb*
bbbb*
bbbb*
XXXX
0000
0000
0000
RESULT
DATA_n
—
—
T
2
1
2
1
No measurement.
Convert the temperature sensor signal using the settings in
ADC_Config_TA and ADC_CONFIG_TB, storing the result in the
ADC_Data_T register.
Convert the differential signal INP2-INM2 using the settings in
ADC_Config_2A and ADC_Config_2B, storing the result in the ADC_Data_2
register.
Convert the differential signal INP1-INM1 using the settings in
ADC_Config_1A and ADC_Config_1B, storing the result in the ADC_Data_1
register.
Not used for any setting of SE[3:0] ≠ 0000.
Convert the single-sided signal indicated by SE[3:0] using the settings in
ADC_Config_2A and ADC_Config_2B, if appropriate, storing the result in
the ADC_Data_2 register.
Convert the single-sided signal indicated by SE[3:0] using the settings in
ADC_Config_1A and ADC_Config_1B, if appropriate, storing the result in
the ADC_Data_1 register.
DESCRIPTION
DESCRIPTION