VT-803-EAE-287B-26M0000000 Vectron, VT-803-EAE-287B-26M0000000 Datasheet
VT-803-EAE-287B-26M0000000
Specifications of VT-803-EAE-287B-26M0000000
Related parts for VT-803-EAE-287B-26M0000000
VT-803-EAE-287B-26M0000000 Summary of contents
Page 1
... VT-803 Vectron’s VT-803 Temperature Compensated Crystal Oscillator (TCXO quartz stabilized, clipped sine wave or CMOS output, 5th order analog temperature compensated oscillator, operating off a 2.8 to 5.0 volt supply in a hermetically sealed 3.2x5 mm ceramic package. Features • Clipped Sine Wave or CMOS Output • ...
Page 2
... Start Up Time 1. The Output is DC coupled and should be AC coupled. 2. The VT-803 power supply pin should be fi ltered, eg, a 10uF, 0.1uF and 0.01uf capacitor. 3. Not all stabilities are available over all temperature ranges, consult Table 9. 4. After 2 IR refl ows and 24 hours. ...
Page 3
... Start Up Time 1. The Output is DC coupled. 2. The VT-803 power supply pin should be fi ltered, eg, a 10uF, 0.1uF and 0.01uf capacitor. 3. Not all stabilities are available over all temperatures, consult Table 10. 4. After 2 IR refl ows and 24 hours. 5. Measured using a Wavecrest SIA3300C, 90K samples. ...
Page 4
... Seconds Figure 1 The VT-803 start up time is rated at 2ms. Figure 1 shows the Output Frequency versus time in seconds which shows the output reaching a steady state frequency within 60 seconds. Allan Deviation, Clipped Sine Wave Output Figure 3 Test Conditions are under room ambient air fl ow (non insulated conditions) ...
Page 5
... Hertz Figure 11 Figure 11 shows the diff erence in the phase noise at 85°C, 25°C and -40°C. Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com 0.2 0.15 0.1 0. -0.05 -0.1 -0.15 -0.2 Figure 8 shows the change in frequency reading between every adjacent 2° ...
Page 6
... VCXO Feature: The VT-803 is supplied with a VCXO function for applications were it will be used in a PLL, or the output frequency needs fi ne tune or calibration adjustments. This is a high impedance input , 100 Kohm, and can be driven with an op-amp or terminated with adjustable resistors etc. Pin 1 should not be left fl oating on the VCXO optional device. ...
Page 7
... Tape Dimensions (mm 5.5 1.5 4 Pin1 Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com IR Refl ow Value 200 sec Max 150°C 200°C 3ºC/sec Max 150 sec Max 480 sec Max 30 sec Max 60 sec Max 6º ...
Page 8
... Table 8. Standard Frequencies (MHz) 10.000 12.800 16.000 40.000 50.000 VT-803 507A- xxMxxxxxxx Product TCXO Package 5x3.2 Package Voltage Options D: +5.0 Vdc ±10% E: +3.3 Vdc ±10% F: +3.0 Vdc ±10% G: +2.8 Vdc ±10% Output A: CMOS F: Clipped Sine Wave Temp Range W: -10/70°C J: -20/70°C H: -30/85°C E: -40/85°C Table 9. Capabilities, Clipped Sine Wave Output ...