MAX3761E/D Maxim Integrated, MAX3761E/D Datasheet - Page 6

• Manufacturer Part Number: MAX3761E/D
• Description: Limiting Amplifiers Low Power 622Mbps Limiting Amplifiers with Chatter Free Power Detect for LANs
• Manufacturer: Maxim Integrated

Specifications of MAX3761E/D

• Operating Supply Voltage: 5 V
• Supply Current: 25 mA
• Operating Temperature Range: + 85 C
• Available Set Gain: 12.5 dB
• Number Of Channels: 1
• Power Dissipation: 591 mW

Low-Power, 622Mbps Limiting Amplifiers
with Chatter-Free Power Detect for LANs
Figure 1. Functional Diagram
Figure 1 shows the functional diagram for the MAX3761/
MAX3762. The input signal is applied to VIN+ and VIN-.
A chain of amplifier stages, each contributing approxi-
mately 12.5dB of gain, amplifies the input signal to
PECL output voltage swings. A 4mVp-p input signal will
cause the output to fully limit.
Each amplifier stage contains a full-wave logarithmic
detector (FWD). The full-wave detector outputs are
summed at the FILTER pin and used to generate the
received-signal-strength indication (RSSI). The RSSI
output voltage is linearly proportional to the input power
(in decibels), and is approximated by:
where V
The RSSI output is insensitive to fluctuations in temperature
and supply voltage. The power detector functions as a
broadband power meter that detects the total power of all
signals present in the passband of approximately 750MHz.
Refer to the Typical Operating Characteristics graphs show-
ing RSSI output versus input power and signal amplitude.
6
_______________Detailed Description
C
FILTER
_______________________________________________________________________________________
VIN+/VIN-
FWD = FULL-WAVE DETECTOR
FILTER
C
IN
V
CC
IN
V
is the peak-to-peak input signal in millivolts.
RSSI
V
CC
(V) = 1.13 + 0.457log (V )
FWD
LIMITER
GND
Received-Signal-Strength
FWD
R1
Indicator (RSSI)
SUB
LIMITER
REF
IN
INV
FWD
CZP
R2
LIMITER
C
AZ
CZN
VTH
The high-speed RSSI signal is filtered with one external
capacitor connected from FILTER to V
ance at the FILTER pin is approximately 500Ω.
The FILTER capacitor (C
to V
The limiting amplifier provides approximately 60dB of
gain. An input DC offset of even 1mV reduces the
power-detection circuit’s accuracy and can cause the
output to limit. A low-frequency feedback loop is inte-
grated into the MAX3761/MAX3762 to remove input off-
set. DC coupling the inputs is not recommended, as
this prevents the DC-offset-correction circuitry from
functioning properly. Input offset is typically reduced to
less than 100μV.
The capacitance between pins CZP and CZN, in parallel
with a 10pF integrated capacitance, determines the off-
set-correction circuit’s time constant. The input imped-
ance between CZP and CZN is approximately 800kΩ.
The offset correction circuitry requires an average data-
input duty cycle of 50%. If the input data has a different
average duty cycle, the output will have increased
pulse-width distortion.
FWD
MAX3761/MAX3762
CC
LIMITER
for proper operation.
EN
Input-Offset Correction
FILTER
GNDO
VCCO
) must be connected
CC
. The imped-
DISABLE
OUT+/OUT-
RSSI
LOS+/LOS-
V
CC
- 2V
50Ω