AP-CF512ME3FR-ETNRK Apacer, AP-CF512ME3FR-ETNRK Datasheet - Page 25
![no-image](/images/no-image-200.jpg)
AP-CF512ME3FR-ETNRK
Manufacturer Part Number
AP-CF512ME3FR-ETNRK
Description
Memory Cards CFC 3 EXT TMP 512MB COMPACT FLASH CARD
Manufacturer
Apacer
Datasheet
1.AP-CF008GE3FR-NRK.pdf
(43 pages)
Specifications of AP-CF512ME3FR-ETNRK
Rohs
yes
Product
Compact Flash
Memory Size
512 MB
Sustained Read
25 MB/s
Sustained Write
5 MB/s
Active Mode Current
80 mA, 95 mA
Operating Supply Voltage
3.3 V, 5 V
Maximum Operating Temperature
+ 70 C
Dimensions
42.8 mm x 36.4 mm x 3.3 mm
Connector Type
50 Pin Female
Minimum Operating Temperature
0 C
T
T
T
T
1.
2.
3.
Notes:
1.
© 2011 Apacer Technology Inc.
Name
DSIC
DHIC
DVSIC
DVHIC
All timing measurement switching point (low-to-high and high-to-low)
The correct data value is captured by the Recipient given input data with a slew rate of 0.4 V/ns rising and falling and the input
STROBE with a slew rate of 0.4 V/ns rising and falling at TDSIC and TDHIC timing (as measured through 1.5 V).
The parameters TDVSIC and TDVHIC are met for lumped capacitive loads of 15 and 40 pf at the IC where all signals have the
same capacitive load value. Noise that may couple onto the output signals from external sources has not been included in
these values.
The definitions for the DIOW-:STOP, DIOR-:HDMARDY-:HSTROBE, and IORDY:DDRARDY-: DSTROBE signal lines are not
in effect until DMARQ and DMACK are asserted.
Recipient IC data setup time (from data valid until STROBE edge)
Recipient IC data hold time (from STROBE edge until data becomes
invalid)
Sender IC data valid setup time (from data valid until STROBE edge)
Table 7-12: Ultra DMA Sender and Recipient IC Timing Specifications
1
Value Added
Figure 7-8: Initiating an Ultra DMA Data-In Burst
AP-CFxxxxE3XR-XXXXXXK
Descriptions
Compact Flash Ⅲ Ⅲ Ⅲ Ⅲ series
24
2
3
Min
4.8
4.8
9.5
9.0
Mode 4
1
Max
Rev. 1.0
Unit
ns
ns
ns
ns