AP-CF512ME3FR-NRK Apacer, AP-CF512ME3FR-NRK Datasheet - Page 24

• Manufacturer Part Number: AP-CF512ME3FR-NRK
• Description: Memory Cards CFC 3 STD TMP 512MB COMPACT FLASH CARD
• Manufacturer: Apacer

Specifications of AP-CF512ME3FR-NRK

• Rohs: yes
• Product: Compact Flash
• Dimensions: 42.8 mm x 36.4 mm x 3.3 mm

1. All timing measurement switching points (low-to-high and high-to-low) are taken at 1.5V.
2. All signal transitions for a timing parameter are measured at the connector specified in the measurement location column. For
3. The parameter TCYC is measured at the recipient’s connector farthest from the Sender.
4. 80-Conductor cabling is required in order to meet sup (TDS, TCS) and hold (TDH, TCH) times in modes greater than two.
5. The parameters TDS and TDH for Mode 5 are defined for a Recipient at the end of the cable only in a configuration with a single
6. Timing for TDVS, TDVH, TCVS, and TCVH are met for lumped capacitive loads of 15 and 50 pf at the connector where the Data
7. The parameters TUI, TMLI, and TLI indicate Sender-to-Recipient or Recipient-to-Sender interlocks. For example, one agent
8. The parameter TLI is measured at the connector of the Sender or Recipient that is responding to an incoming transition from the
9. The parameter TAZ is measured at the connector of the Sender or Recipient that is driving the bus but must release the bus that
10. For all modes the parameter TZIORDY may be greater than TENV because the host has a pull-on IORDY giving it a known
© 2011 Apacer Technology Inc.
example, in the case of TRFS, both STROBE and DMARDY Transitions are measured at the Sender connector.
device located at the end of the cable. This could result in the minimum values for TDS and TDH for mode 5 at the middle
connector being 3.0 and 3.9 ns respectively.
and STROBE signals have the same capacitive load value. Due to reflections on the cable, these timing measurements are not
valid in a normally functioning system.
(either Sender or Recipient) is waiting for the other agent to respond with a signal before proceeding; TUI is an unlimited
interlock that has no maximum time value, TMLI is a limited time-out that has a defined minimum, and TLI is a limited time-out
that has a defined maximum.
Recipient or Sender respectively. Both the incoming signal and the outgoing response are measured at the same connector.
allow for a bus turnaround.
state when released.
Value Added
AP-CFxxxxE3XR-XXXXXXK
Compact Flash Ⅲ Ⅲ Ⅲ Ⅲ series
23
Rev. 1.0