AT88SC0104CA-PU Atmel, AT88SC0104CA-PU Datasheet - Page 27

• Manufacturer Part Number: AT88SC0104CA-PU
• Description: IC EEPROM 1KBIT 4MHZ 8DIP
• Manufacturer: Atmel
• Series: CryptoMemory®r

Specifications of AT88SC0104CA-PU

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 1K (128 x 8)
• Speed: 4MHz
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• For Use With: AT88SC-SDK1 - KIT TUEMA DK CRYPTOMEM SMARTCARDAT88SC-DK1 - KIT DEV FOR AT88SCXXXXC FAMILY
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8.
8.1.
26
Synchronous Protocol
Communication with Atmel
Atmel AT24Cxxx Serial EEPROM devices using a two-wire protocol (TWI). Basic command structure and timing are the
same however a significant difference exists when reading the CryptoMemory device that will be described below.
Start-up Sequence
When first powering up the device, five pulses are required on CLK-SCL for reading of internal registers. This may be
accomplished by sending one full command byte to the device. The device will not respond but will then be ready to
respond to the next correct command sequence.
• Power-up V
• External pull-up resistor pulls I/O-SDA high with V
• After stable V
• CLK-SCL and I/O-SDA may be driven.
Figure 11. Start-up Sequence
CLK-SCL
Atmel AT88SC0104/0204/0404/0808/CA
I/O-SDA
V cc
CC
CC
, 5 pulses are applied to CLK-SCL
®
CryptoMemory
1
2
3
®
using the synchronous protocol is very similar to communication with
4
CC
5
8664C–CRYPT–01/10