EVAL-AD5445SDZ Analog Devices, EVAL-AD5445SDZ Datasheet - Page 4

• Manufacturer Part Number: EVAL-AD5445SDZ
• Description: Data Conversion IC Development Tools EVALUATION BOARD
• Manufacturer: Analog Devices
• Type: DACr

Specifications of EVAL-AD5445SDZ

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: AD5445
• Interface Type: USB
• Operating Supply Voltage: 2.5 V to 5.5 V
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Current: 0.6 uA
• Factory Pack Quantity: 1
• For Use With: EVAL-SDP-CB1Z

UG-333
EVALUATION BOARD SOFTWARE
INSTALLING THE SOFTWARE
The
the software and drivers. To install the software, follow these steps:
1.
2.
3.
4.
5.
EVAL-AD5445SDZ
Install the software before connecting the SDP board to the
USB port of the PC.
Start the Windows® operating system, and insert the CD
included in the
Download the
correct driver, SDPDriversNET, for the SDP board should
download automatically after LabVIEW is downloaded,
supporting both 32- and 64-bit systems. However, if the
driver does not download automatically, the driver executable
file can also be found in the Analog Devices folder (from the
Start menu, point to All Programs and then click Analog
Devices). Follow the on-screen prompts to install the driver.
After installation of the software and drivers is complete,
plug the
the SDP board into the PC using the USB cable included in
the evaluation board kit.
When the software detects the evaluation board, proceed
through any dialog boxes that appear to finalize the
installation (such as Found New Hardware Wizard/Install
the Software Automatically).
EVAL-AD5445SDZ
EVAL-AD5445SDZ
EVAL-AD5445SDZ
evaluation kit includes a CD containing
into the SDP board and plug
LabVIEW® software. The
evaluation board kit.
Figure 4. Device Manager Showing the SDP Board Connected
Rev. 0 | Page 4 of 12
RUNNING THE SOFTWARE
To run the evaluation board program,
1.
2.
From the Start menu, point to All Programs and then
click Analog Devices and EVAL-AD5445SDZ.
If the SDP board is not connected to the USB port when
the software is launched, a connectivity error displays (see
Figure 3.). If this message appears, connect the evaluation
board to the USB port of the PC, wait a few seconds, click
Rescan, and follow the on-screen instructions.
Evaluation Board User Guide
Figure 3. Connectivity Error