AT27C040-90PU Atmel, AT27C040-90PU Datasheet - Page 3

• Manufacturer Part Number: AT27C040-90PU
• Description: IC OTP 4MBIT 90NS 32DIP
• Manufacturer: Atmel

Specifications of AT27C040-90PU

• Format - Memory: EPROMs
• Memory Type: OTP EPROM
• Memory Size: 4M (512K x 8)
• Speed: 90ns
• Interface: Parallel
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-DIP (0.600", 15.24mm)
• Capacitance, Input: 4 pF
• Capacitance, Output: 8 pF
• Current, Input, Leakage: ±1 μA
• Current, Operating: 30 mA (Read)
• Current, Output, Leakage: ±5
• Density: 4M
• Organization: 512K×8
• Package Type: PDIP
• Temperature, Operating: -40 to +85 °C
• Time, Access: 90 ns
• Time, Address Setup: 2
• Time, Fall: 20 ns
• Time, Rise: 20 ns
• Voltage, Esd: 2000 V
• Voltage, Input, High: 5.5 V (Read)
• Voltage, Input, Low: 0.8 V (Read)
• Voltage, Output, High: 2.4 V (Read)
• Voltage, Output, Low: 0.4 V (Read)
• Voltage, Supply: 5 V
• Access Time: 70 ns
• Supply Voltage (min): 4.5 V
• Maximum Operating Temperature: + 85 C
• Interface Type: Parallel
• Minimum Operating Temperature: - 40 C
• Mounting Style: Through Hole
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3. Switching Considerations
4. Block Diagram
5. Absolute Maximum Ratings*
0189H–EPROM–12/07
Temperature Under Bias................................ -55°C to +125°C
Storage Temperature ..................................... -65°C to +150°C
Voltage on Any Pin with
Respect to Ground ............................................-2.0V to +7.0V
Voltage on A9 with
Respect to Ground .........................................-2.0V to +14.0V
V
Respect to Ground ..........................................-2.0V to +14.0V
PP
Supply Voltage with
Switching between active and standby conditions via the Chip Enable pin may produce tran-
sient voltage excursions. Unless accommodated by the system design, these transients may
exceed datasheet limits, resulting in device non-conformance. At a minimum, a 0.1 µF high
frequency, low inherent inductance, ceramic capacitor should be utilized for each device. This
capacitor should be connected between the V
to the device as possible. Additionally, to stabilize the supply voltage level on printed circuit
boards with large EPROM arrays, a 4.7 µF bulk electrolytic capacitor should be utilized, again
connected between the V
close as possible to the point where the power supply is connected to the array.
CC
and Ground terminals. This capacitor should be positioned as
*NOTICE:
CC
Stresses beyond those listed under “Absolute
Maximum Ratings” may cause permanent dam-
age to the device. This is a stress rating only and
functional operation of the device at these or any
other conditions beyond those indicated in the
operational sections of this specification is not
implied. Exposure to absolute maximum rating
conditions for extended periods may affect
device reliability.
and Ground terminals of the device, as close
AT27C040
3