MIKROE-648 mikroElektronika, MIKROE-648 Datasheet - Page 7

• Manufacturer Part Number: MIKROE-648
• Description: Development Boards & Kits - ARM EASYARM V6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-648

• Rohs: yes
• Product: Development Kits
• Tool Is For Evaluation Of: LPC2148, LPC2214
• Core: ARM7TDMI-S
• Interface Type: RS-232, SPI, UART, USB
• Operating Supply Voltage: 5 V, 9 V to 32 V
• Data Bus Width: 32 bit
• Description/function: Development Board Only, Touch Screen, Pencil, DS1820, LCD, Serial Cable, GLCD not included
• Dimensions: 265 mm x 220 mm
• Processor Series: LPC2xxx
• For Use With: LPC2148, LPC2214

7
EasyARM v6
2. Connecting EasyARM v6 to a PC
The EasyARM v6 development system comes with the mikroBoard for ARM provided with a USB connector. This
connector enables the development system to be connected to a PC. It is also possible to provide the system with
the 5V power supply voltage from the PC via this connector. The mikroBoard for ARM may be used as a stand-alone
device. When connecting the mikroBoard for ARM card to the development system, it is necessary to remove jumper
marked STANDALONE. For more information on the mikroBoard for ARM, refer to the relevant manual.
1
2
Figure 2-1: Connecting the development system to a PC
Figure 2-2: mikroBoard for ARM
In addition to the mikroBoard for ARM, the development system can also be connected to a PC via USB UART 1 or
USB UART2 module supplied on the development system or via a USB connector used for USB communication. It’s
also possible to connect development system via RS-232 port.
MikroElektronika