MIKROE-419 mikroElektronika, MIKROE-419 Datasheet - Page 9

• Manufacturer Part Number: MIKROE-419
• Description: Development Boards & Kits - PIC / DSPIC BIGPIC6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-419

• Rohs: yes
• Product: Development Kits
• Core: PIC
• Interface Type: ICD, IDC10, JTAG, RS-232, USB
• Operating Supply Voltage: 9 V to 32 V
• Data Bus Width: 8 bit
• Description/function: Development Board Only, Touch Screen, Pencil, DS1820, LCD, Serial Cable, GLCD not included
• Dimensions: 265 mm x 220 mm
• For Use With: PIC

BigPIC6 Development System
BigPIC6 Development System
3.0. On-board USB 2.0 PICfl ash with mikroICD Programmer
A programmer is a necessary tool when working with the microcontroller. The BigPIC6 development system has an on-board PICfl ash
programmer with mikroICD support which allows you to establish a connection between the microcontroller and your PC. Use the
PICfl ash program to load a .hex fi le into the microcontroller. Figure 3-2 shows the connection between a compiler, PICfl ash programmer
and microcontroller.
Figure 3-2: The principle of programmer’s operation
NOTE:
Write a code in some of PIC compilers, generate
a .hex fi le and load data into the microcontroller
usng the on-board programmer.
For more information on the PICfl ash programmer refer to the relevant manual provided in the BigPIC6 development
system package.
LED diode marked as PRG/ICD will
be turned on during programming the
microcontroller
LED diode marked as USB LINK
indicates connection established
between programmer and PC
1
USB type B connector
Compiling program
Click the Load button to
load HEX code
1110001001
0110100011
0111010000
1011011001
Hex.
Figure 3-1: PICfl ash programmer
2FC23AA7
F43E0021A
DA67F0541
Bin.
2
3
compilers and generate a .hex fi le;
select the microcontroller to be
programmed and load the .hex fi le;
program into the microcontroller.
1
2
3
Write a program in some of PIC
Use the PICfl ash program to
Click the Write button to load the
On the left side of the PICfl ash
program’s window there are a
number of options used for setting
parameters for the operation of
the microcontroller. On the right
side of the window there are a
number of buttons which enable
the HEX. code to be loaded into
the microcontroller. Positioned
in the bottom right corner of the
window, the Progress bar enables
you to monitor the programming
progress.
MikroElektronika
9