MIKROE-453 mikroElektronika, MIKROE-453 Datasheet - Page 6

• Manufacturer Part Number: MIKROE-453
• Description: Development Boards & Kits - PIC/DSPIC LV18F V6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-453

• Rohs: yes
• Product: Development Kits
• Core: PIC
• Interface Type: ICD, IDC10, JTAG, RS-232, USB
• Operating Supply Voltage: 5 V, 9 V to 32 V
• Data Bus Width: 8 bit
• Description/function: Development Board Only, Touch Screen, Pencil, DS1820, LCD, Serial Cable, GLCD not included
• Dimensions: 265 mm x 220 mm
• For Use With: PIC

6
MikroElektronika
1.0. Connecting the System to a PC
Step 1:
Follow the instructions provided in the relevant manuals and install the LV18PICfl ash program and USB drivers from the product CD.
USB drivers are necessary for the proper operation of the on-board programmer.
In case you already have some of the MikroElektronika’s PIC compilers installed on your PC, there is no need to reinstall USB drivers
as they will automatically be installed along with the compiler.
Step 2:
Use the USB cable to connect the LV 18F v6 development system to a PC. One end of the USB cable, with a connector of the USB
B type, should be connected to the development system, as shown in Figure 1-2, whereas the other end of the cable (USB A type)
should be connected to a PC. When establishing a connection, make sure that jumper J10 is placed in the USB position as shown in
Figure 1-1.
Step 3:
Turn on your development system by setting the POWER SUPPLY switch to the ON position. Two LEDs marked as POWER and USB
LINK will automatically illuminate indicating that your development system is ready to use. Use the on-board programmer and the
LV18PICfl ash program to dump a code into the microcontroller and employ the system to test and develop your projects.
NOTE:
J10 power supply
selector
Figure 1-3 : Placing additional modules on the board
If some additional modules are used, such as LCD, GLCD etc, it is necessary to place them properly on the development
system while it is turned off. Otherwise, either can be permanently damaged. Refer to Figure below for the proper placing of
additional modules.
Figure 1-1: Power supply
DC connector
USB connector
POWER SUPPLY switch
Figure 1-2: Connecting USB cable
1
2
LV 18F v6 Development System
LV 18F v6 Development System