MIKROE-411 mikroElektronika, MIKROE-411 Datasheet - Page 24

• Manufacturer Part Number: MIKROE-411
• Description: Development Boards & Kits - PIC / DSPIC EASYPIC6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-411

• Rohs: yes
• Product: Development Kits
• Core: PIC
• Interface Type: CAN, IDC10, JTAG, RS-232, USB
• Operating Supply Voltage: 9 V to 32 V
• Data Bus Width: 8 bit
• Description/function: Development Board Only, Touch Screen, Pencil, DS1820, LCD, Serial Cable, GLCD are not included
• Dimensions: 265 mm x 220 mm
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• For Use With: PIC16F887

24
MikroElektronika
19.0. Input/Output Ports
Along the right side of the development system, there are seven 10-pin connectors which are connected to the microcontroller’s I/O ports.
Some of the connector’s pins are directly connected to the microcontroller pins, whereas some of them are connected using jumpers. DIP
switches SW1-SW5 enable each connector pin to be connected to one pull-up/pull-down resistor. Whether port pins are to be connected to
a pull-up or pull-down resistor depends on the position of jumpers J1-J5.
Figure 19-4: PORTB schematic connection
Jumper for pull-up/ pull-
down resistor selection
DIP switch
on
resistors for each pin
Jumper J2 in the pull-down position
pull-up/pull-down
to
turn
Figure 19-1: I/O ports
2x5 PORTA male connector
Additional module connected
to PORTC
EasyPIC6 Development System
Figure 19-2: J2 in the
pull-down position
pull-up position
J2 in the