STEVAL-MKI111V1 STMicroelectronics, STEVAL-MKI111V1 Datasheet - Page 5

• Manufacturer Part Number: STEVAL-MKI111V1
• Description: Development Boards & Kits - Other Processors LPS001WP Water Level Detection Eval BRD
• Manufacturer: STMicroelectronics

Specifications of STEVAL-MKI111V1

• Product Category: Development Boards & Kits - Other Processors
• Rohs: yes

UM1502
1
1.1
1.2
1.3
1.3.1
1.3.2
System introduction
Main features
The main features of the STEVAL-MKI111V1 demonstration board are:
●
●
●
●
●
●
●
●
●
Target applications
As a water level detection demonstration board, the STEVAL-MKI111V1 is mainly targeted
at the home appliance market for applications including:
●
●
●
Safety and operating instructions
General terms
The STEVAL-MKI111V1 demonstration board is designed for demonstration purposes only,
and must not be used in domestic or industrial installations. The technical data, as well as
the information concerning the power supply and working conditions, must be taken from
the documentation included in the kit and strictly observed.
Intended use
Input voltage range: 5-12 V DC or direct 3.3 V DC power supply
LPS001WP MEMS pressure sensor, 300-1100 mbar absolute digital output barometer
20-pin, 8-bit STM8S103F2 MCU as main controller
Output signal interfaces available:
–
–
Onboard or external MEMS control (by selector)
“Zero” button to reset the pressure offset
RUN LED, OFS LED, and 5-step indicator bar
Standard in-circuit programming connector (SWIM, single wire interface module)
RoHS compliant.
Domestic or industrial washing machines
General purpose water level systems
Respiratory equipment.
Warning:
I²C interface
PWM modulation (43-38 Hz)
This demonstration board must be used in a suitable
laboratory environment only, by qualified personnel who are
familiar with the installation, use, and maintenance of
electrical systems.
Doc ID 022625 Rev 1
System introduction
5/23