EVL6699-150W-SR STMicroelectronics, EVL6699-150W-SR Datasheet - Page 2

• Manufacturer Part Number: EVL6699-150W-SR
• Description: Power Management IC Development Tools L6699 Trans Mode PFC Eval Board
• Manufacturer: STMicroelectronics
• Type: Power Factor Correctionr

Specifications of EVL6699-150W-SR

• Product Category: Power Management IC Development Tools
• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: L6699
• Input Voltage: 90 V to 264 V
• Output Voltage: 12 V

Description
1
2/6
Description
The EVL6699-150W-SR board is made up of two stages: a front-end PFC using the
L6563H, an LLC resonant converter based on the L6699 and the SRK2000, controlling the
SR MOSFETs on the secondary side. The SR driver and the rectifier MOSFETs are
mounted on a daughterboard.
The L6563H is a current mode PFC controller operating in transition mode and implements
a high voltage startup source to power on the converter.
The L6699 integrates all the functions necessary to properly control the resonant converter
with a 50% fixed duty cycle and working with variable frequency.
The output rectification is managed by the SRK2000, an SR driver dedicated to LLC
resonant topology.
The PFC stage works as pre-regulator and powers the resonant stage with a constant
voltage of 400 V. The downstream converter operates only if the PFC is on and regulating.
In this way, the resonant stage can be optimized for a narrow input voltage range.
The L6699's LINE pin (pin 7) is dedicated to this function. It is used to prevent the resonant
converter from working with too low input voltage that can cause incorrect capacitive mode
operation. If the bulk voltage (PFC output) is below 380 V, the resonant startup is not
allowed. The L6699 LINE pin internal comparator has a hysteresis allowing the turn-on and
turn-off voltage to be independently set. The turn-off threshold has been set to 300 V
allowing the resonant stage to operate in the case of mains sag and consequent PFC output
dip.
The transformer uses the integrated magnetic approach, incorporating the resonant series
inductance. Therefore, no external, additional coil is needed for the resonance. The
transformer configuration chosen for the secondary winding is centre tap.
On the secondary side, the SRK2000 core function switches on each synchronous rectifier
MOSFET whenever the corresponding transformer half-winding starts conducting (i.e. when
the MOSFET body diode starts conducting) and then switches it off when the flowing current
approaches zero. For this purpose, the IC is provided with two pins (DVS1 and DVS2)
sensing the MOSFETs drain voltage level.
The SRK2000 automatically detects light load operation and enters Sleep mode, disabling
MOSFET driving and decreasing its own consumption. This function allows great power
saving at light load with respect to benchmark SR solutions.
In order to decrease the output capacitor size, aluminium solid capacitors with very low ESR
were preferred to standard electrolytic ones. Therefore, high frequency output voltage ripple
is limited and output LC filter is not required. This choice allows the saving of output inductor
power dissipation which can be significant in the case of high output current applications
such as this.
Doc ID 023380 Rev 1
EVL6699-150W-SR