LED Engin
ViviLux Emitter + Lens Kit
ViviLux™ Starter Kit
Assembly Instructions
|
651 River Oaks Parkway
1. If the Starter Kit assembly will be used for demonstration on a table top, the fan
2. To adopt the assembly for this orientation, remove the screws from the base of
3. Remove the protective cover from one side of the 3M Thermally Conductive
4. Remove remaining protective cover from the 3M Thermally Conductive Interface
5. Attach the LED emitter/board to the Cooliance High Power LED Heatsink Cooler
6. Attach the wiring harness connector to the Cooliance Coolstrate High Power LED
7. Attach wires to the LED emitter/board connector that is marked “LED.”
8. Using a single wire nut, connect all red wires from LED emitter/board, Cooliance
of the cooler requires clearance from the table top surface. Well nuts and
extended screws are supplied with the kit to provide this option.
the Cooliance Coolstrate High Power LED Heatsink Cooler one by one and
replace them with the supplied extended screws and well nuts.
Interface Pad (Acrylic Elastomer) pre-cut for LED Engin LZC 49.9 mm diameter
MC-PCB: 5590-H-50 and carefully adhere it to the backside of the LED
emitter/board, lining up the cutouts with the holes in the LED emitter/board.
Pad and place the LED emitter/board onto the top of the Cooliance Coolstrate
High Power LED Heatsink Cooler ensuring that the screw holes are visible and
orienting it so that the LED wire connector on the LED emitter/board is positioned
on the same side of the Cooliance Coolstrate High Power LED Heatsink Cooler
as the fan connectors.
using four (4) M3 screws and plastic washers. This should be done by tightening
the M3 screws in a sequence of steps analogous to how one tightens the lugs for
the wheel of an automobile. Maximum torque should not exceed 1 Nm (0.74 lb·ft).
Heatsink Cooler.
Red wire positive (+); Black wire negative (-). Poke-home connectors have
a friction fit. You should push wires in all the way and give a slight tug to confirm
they are engaged. Double check your work to insure proper polarity. The negative
lead (black) should be on the outside edge of this connector. The connector for the
thermistor will not be used.
Coolstrate High Power LED Heatsink Cooler and the low voltage side (DC Out) of
the Mean Well, 25 W, Single Output, LED Power Supply together.
|
San Jose, CA 95134 USA
|
ph +1 408 922 7200
|
fax +1 408 922 0158
ViviLux Starter Kit Assembly Instructions (1.0-11/01/12)
|
em sales@ledengin.com
|
www.ledengin.com