88-00151-85 Murata Wireless Solutions, 88-00151-85 Datasheet - Page 26
![no-image](/images/no-image-200.jpg)
88-00151-85
Manufacturer Part Number
88-00151-85
Description
WiFi / 802.11 Development Tools Wi-FiNetworkControlr Module EVAL Kit
Manufacturer
Murata Wireless Solutions
Datasheet
1.88-00151-85.pdf
(29 pages)
Specifications of 88-00151-85
Rohs
yes
Product
Development Kits
Tool Is For Evaluation Of
88-00151-00
Protocol Supported
802.11 b/g/n
Frequency
2.4 GHz
Interface Type
I2C, SPI, UART
Operating Supply Voltage
3.3 V
Part # Aliases
88-00151-95
Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence (s). Son
utilisation est soumise à Les deux conditions suivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter Toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement du dispositif.
This device complies with Health Canada’s Safety Code 6 / IC RSS-210. The installer of this device
should ensure that RF radiation is not emitted in excess of the Health Canada’s requirement.
Information can be obtained at:
lignes_direct-eng.php
Cet appareil est conforme avec Santé Canada Code de sécurité 6 / IC RSS-210. Le programme
d'installation de cet appareil doit s'assurer que les rayonnements RF n'est pas émis au-delà de
l'exigence de Santé Canada. Les informations peuvent être obtenues: http://www.hc-sc.gc.ca/ewh-
semt/pubs/radiation/radio_guide-lignes_direct-eng.php
The host device should be properly labeled to identify the module within the host device. The
Industry Canada certification label of a module shall be clearly visible at all times when installed in
the host device, otherwise the host device must be labeled to display the Industry Canada
certification number of the module, preceded by the words “Contains transmitter module”, or the
word “Contains”, or similar wording expressing the same meaning, as follows:
Contains transmitter module IC:4523A-SN8200,
where 4523A-SN8200 is the module’s certification number.
This device has been tested and certified for use in the European Union.
If this device is used in a product, the OEM has responsibility to verify compliance of the final
product to the EU standards. A Declaration of Conformity must be issued and kept on file as
described in Annex II of the Radio and Telecommunications Terminal Equipment Directive.
The ‘CE’ mark must be placed on the OEM product per the labeling requirements of the Directive.
Given that the operating frequency band is not harmonized by a few European countries, the
restriction or alert sign must be placed alongside the ‘CE’ mark as shown below. As of the date of
this document, only France has a restriction. The restriction is that, if the radio is operated outdoors
in the 2450-2483.5 MHz band, the power must be limited to 10 mW instead of 100 mW. The OEM
must account for this and the product must have the alert mark. It does not require country
notifications, however.
11.5 IC Labeling Requirements
11.6 CE Notice (Europe)
11.7 CE Labeling Requirements
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-
Page 26 of 29
SN8200 User Manual and Datasheet v1.1