MDEV-900-NT Linx Technologies, MDEV-900-NT Datasheet - Page 8

• Manufacturer Part Number: MDEV-900-NT
• Description: RF Development Tools NT Series Dev kit w/ Transparent module
• Manufacturer: Linx Technologies
• Type: RF Transceiversr

Specifications of MDEV-900-NT

• Rohs: yes
• Product: Development Kits
• Tool Is For Evaluation Of: TRM-900-NT
• Frequency: 902 MHz to 928 MHz
• Operating Supply Voltage: 2.5 V to 5.5 V
• Interface Type: USB
• Factory Pack Quantity: 1

• Make sure that the Baud Rate and Channel switches are set the same
• Check that the antennas are connected
• Make sure that a jumper is installed on the Module Power Header
• Make sure that the batteries are not dead
If all of these appear to be in order, please call [phone] or e-mail
[e-mail] for technical support.
The Prototyping Area
In addition to its evaluation functions, the board may also be used for
product development. It features a prototyping area to facilitate the addition
of application-specific circuitry (Figure 4). The prototyping area contains a
large area of plated through-holes so that external circuitry can be placed
on the board. The holes are set at 0.100" on center with a 0.040" diameter,
accommodating most industry-standard SIP and DIP packages.
External circuitry can be easily interfaced to the NT transceiver through the
breakout header (TS1) to the right of the prototyping area. The Mode Select
switch should be set to the left position to enable the module’s lines to
be controlled from the prototyping area. At the bottom of the prototyping
area is a row connected to the 5V power supply and at the top is a row
connected to ground.
Note:
for additional circuitry. If more current is required, the user must add an
additional regulator or power the board from an external supply.
on both boards
The onboard 5-volt regulator has approximately 600mA available
Figure 4: The Development Board
Prototyping Area
–
4
–