DLP-RFS-DK DLP Design, DLP-RFS-DK Datasheet - Page 39

• Manufacturer Part Number: DLP-RFS-DK
• Description: RF Development Tools DLP-RFS1231 development kit
• Manufacturer: DLP Design
• Type: RF Transceiversr

Specifications of DLP-RFS-DK

• Rohs: yes
• Product: Development Kit
• Tool Is For Evaluation Of: DLP-RFS1231
• Frequency: 915 MHz
• Operating Supply Voltage: 2.4 V to 3.6 V
• Dimensions: 1.5 in x 2 in x 1.53 in
• Interface Type: UART
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• For Use With: DLP-RFS1231

PART NUMBER
US / FCC
CANADA / IC
DLP-RFS1231
SX9RFS1
5675A-RFS1
6.2 EXTERNAL ANTENNAS
The DLP-RFS1231 is preapproved for use with both its on-board chip antenna and an external
antenna (Part No. 0600-00048 made by Laird Technologies). Connection to the external antenna is
made via a u.fl connector.
6.3 FCC/IC REQUIREMENTS FOR MODULAR APPROVAL
Any changes or modifications to the DLP-RFS1231’s printed circuit board, on-board antenna or
pre-approved external antenna could void the user’s authority to operate the equipment.
6.4 WARNINGS
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference; and (2), this device must accept any interference received, including interference that
may cause undesirable operation.
This device is intended for use under the following conditions:
1. The transmitter module may not be co-located with any other transmitter or antenna; and,
2. The module will be approved using the FCC’s “unlicensed modular transmitter approval” method.
As long as these two conditions are met, further transmitter testing will not be required. However, the
OEM integrator is still responsible for testing their end product for any additional compliance
measures necessitated by the installation of this module (i.e. digital device emissions, PC peripheral
requirements, etc.).
Note: In the event that these conditions cannot be met (i.e. co-location with another transmitter), then
the FCC authorization is no longer valid, and the corresponding FCC ID may not be used on the final
product. Under these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
6.5 OEM PRODUCT LABELING
The final end product must be labeled in a visible area with the following text:
“Contains TX FCC ID: SX9RFS1”
© DLP Design, Inc.
Rev 1.1 (November 2012)
39