FEBFCM8531DVK_B01A Fairchild Semiconductor, FEBFCM8531DVK_B01A Datasheet - Page 16

• Manufacturer Part Number: FEBFCM8531DVK_B01A
• Description: Power Management IC Development Tools MCDS Programming kit
• Manufacturer: Fairchild Semiconductor
• Type: Motor / Motion Controllers & Driversr

Specifications of FEBFCM8531DVK_B01A

• Rohs: yes
• Product: Motor Control Kits
• Tool Is For Evaluation Of: FEBFCM8531_B01H300A
• Input Voltage: 5 V
• Output Voltage: 2.5 V
• Interface Type: I2C, SPI, UART
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: -40 C
• Output Current: 29 mA
• For Use With: MCS51

AN-8207
Review Debugger Settings
The debugger needs the Keil C uVision, MCDS
Programming Kit, and USB device driver to properly
perform debugging functions. If any one of them is missing,
an unexpected error may occur. If the debugger works
improperly, the steps below might help to solve the issue.



© 2009 Fairchild Semiconductor Corporation
Rev. 1.0.0 • 2/18/13
Verify the USB device driver is installed properly or re-
install it. Please refer to Software Installation to install
the USB device driver.
Verify the Keil C Debug Mode is installed properly or
re-install it. Please refer to Software Installation to
install the Keil C Debug Mode.
Verify the cables are connected properly. Turn off the
power of the target board and connect the flat cable of
the MCDS Programming Kit to the target board, then
connect the USB cable with PC. Please refer to MCDS
Programming Kit to connect the cables.
Figure 39. Debug Mode
16




Note:
8.
Turn on the power of the target board.
Verify the project is opened correctly or re-open the
project in Keil C uVision by selecting Project  Open
Project, then selecting the correct project. It is also
possible to use the Transfer to Keil C function of the
MCDS IDE.
Verify the Debug Mode settings are correct. Please
refer to the Debug Mode Settings and Using a Fairchild
Chip in Keil C uVision to set the Debug Mode.
Please refer to the user’s manual of Keil C uVision for
the operation of the debugger.
The MCDS Programming Kit is a non-isolated design. Please
pay attention to the devices connected to the target board;
including the PC, PC monitor, Oscillator Scope, DVM, etc.
Fairchild recommends using an USB isolator and removing
the earth ground wire of the power plugs connected to the
target board to avoid the damage to the board and devices.
www.fairchildsemi.com
APPLICATION NOTE