MAX5988BEVKIT# Maxim Integrated, MAX5988BEVKIT# Datasheet - Page 11

• Manufacturer Part Number: MAX5988BEVKIT#
• Description: Power Management IC Development Tools MAX5988B Eval Kit
• Manufacturer: Maxim Integrated

Specifications of MAX5988BEVKIT#

• Rohs: yes

Maxim Integrated
IEEE 802.3af-Compliant, High-Efficiency, Class 1/Class 2,
PIN
10
11
12
13
14
15
16
17
18
19
20
—
7
8
9
Powered Devices with Integrated DC-DC Converter
LDO_FB
CLASS2
RESET
NAME
PGND
VDRV
RREF
GND
WAD
MPS
ULP
V
V
WK
EP
SL
DD
CC
Ground. Reference rail for the device. It is also the “quiet” ground for all voltage references (e.g., FB is
referenced to this GND).
Internal 5V Regulator Voltage Output. The internal voltage regulator provides 5V to the MOSFET driver
and other internal circuits. VDRV is referenced to GND. Do not use VDRV to drive external circuits.
Connect a 1FF bypass capacitor between VDRV and GND.
Sleep Mode Enable Input. A falling edge on SL brings the device into sleep mode. An external resistor
(R
Ultra-Low Power-Mode Enable Input. ULP has an internal 50kω pullup resistor to the internal 5V bias
rail. A falling edge on SL while ULP is asserted low enables ultra-low power mode. When ultra-low
power mode is enabled, the power consumption of the device is reduced even lower than sleep mode
to comply with ultra-low power sleep power requirements while still supporting MPS.
Class 2 Selection Pin. Connect to VDRV for Class 2 operation. Connect to GND for Class 1 operation.
MPS Enable Pin. Connect to VDRV to turn the MPS function on. Connect to GND to turn the MPS
function off.
Open-Drain RESET Output. The RESET output is driven low if either LDO_OUT or FB drops below
90% of its set value. RESET goes high 4.8ms after both LDO_OUT and FB rise above 95% of their set
values. Leave unconnected when not used.
LDO Regulator Feedback Input. Connect to VDRV to get the preset LDO output voltage of 3.3V, or
connect to a resistive divider from LDO_OUT to GND for an adjustable LDO output voltage.
Wake Mode Enable Input. WK has an internal 50kω pullup resistor to the internal 5V bias rail. A falling
edge on WK brings the device out of sleep mode and into the normal operating mode (wake mode).
Wall Power Adapter Detector Input. Wall adapter detection is enabled when the voltage from WAD
to GND is greater than 8.8V. When a wall power adapter is present, the isolation p-channel power
MOSFET turns off. Connect WAD directly to GND when the wall power adapter or other auxiliary power
source is not used.
Positive Supply Input. Connect a 68nF (min) bypass capacitor between V
DC-DC Converter Power Input. V
10FF capacitor in parallel with a 1FF ceramic capacitor between V
Power Ground. Power ground of the DC-DC converter power stage. Connect PGND to GND with a star
connection. Do not use PGND as reference for sensitive feedback circuit.
Signature Resistor Connection. Connect a 24.9kω resistor (R
Exposed Pad. Connect the exposed pad to GND.
SL
) connected between SL and GND sets the LED current (I
DD
is connected to V
FUNCTION
MAX5988A/MAX5988B
CC
Pin Description (continued)
by an isolation p-channel MOSFET. Connect a
SIG
LED
) to GND.
).
CC
and PGND.
DD
and PGND.
11