M25P80-VMP6G NUMONYX, M25P80-VMP6G Datasheet - Page 12
![IC FLASH 8MBIT 75MHZ 8VFQFPN](/photos/19/5/190520/42268234_sml.jpg)
M25P80-VMP6G
Manufacturer Part Number
M25P80-VMP6G
Description
IC FLASH 8MBIT 75MHZ 8VFQFPN
Manufacturer
NUMONYX
Series
Forté™r
Specifications of M25P80-VMP6G
Format - Memory
FLASH
Memory Type
FLASH
Memory Size
8M (1M x 8)
Speed
75MHz
Interface
SPI, 3-Wire Serial
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
-40°C ~ 85°C
Package / Case
8-VFQFN, 8-VFQFPN
Clock Frequency
50MHz
Supply Voltage Range
2.7V To 3.6V
Memory Case Style
VFQFPN
No. Of Pins
8
Base Number
25
Frequency
75MHz
Ic Generic
RoHS Compliant
Memory Configuration
1M X 8
Interface Type
Serial, SPI
Rohs Compliant
Yes
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
M25P80-VMP6G
Manufacturer:
ST
Quantity:
20 000
Operating features
4
4.1
4.2
4.3
12/52
Operating features
Page Programming
To program one data byte, two instructions are required: Write Enable (WREN), which is one
byte, and a Page Program (PP) sequence, which consists of four bytes plus data. This is
followed by the internal Program cycle (of duration t
To spread this overhead, the Page Program (PP) instruction allows up to 256 bytes to be
programmed at a time (changing bits from 1 to 0), provided that they lie in consecutive
addresses on the same page of memory.
For optimized timings, it is recommended to use the Page Program (PP) instruction to
program all consecutive targeted bytes in a single sequence versus using several Page
Program (PP) sequences with each containing only a few bytes (see
and
Sector Erase and Bulk Erase
The Page Program (PP) instruction allows bits to be reset from 1 to 0. Before this can be
applied, the bytes of memory need to have been erased to all 1s (FFh). This can be
achieved either a sector at a time, using the Sector Erase (SE) instruction, or throughout the
entire memory, using the Bulk Erase (BE) instruction. This starts an internal Erase cycle (of
duration t
The Erase instruction must be preceded by a Write Enable (WREN) instruction.
Polling During a Write, Program or Erase Cycle
A further improvement in the time to Write Status Register (WRSR), Program (PP) or Erase
(SE or BE) can be achieved by not waiting for the worst case delay (t
Write In Progress (WIP) bit is provided in the Status Register so that the application program
can monitor its value, polling it to establish when the previous Write cycle, Program cycle or
Erase cycle is complete.
Table 15: AC characteristics (75 MHz operation, Grade
SE
or t
BE
).
PP
).
6)).
W
Page Program
, t
PP
, t
SE
, or t
BE
M25P80
(PP),
). The