AT88SC25616C-CI Atmel, AT88SC25616C-CI Datasheet - Page 5
![IC EEPROM 256KBIT 1.5MHZ 8LAP](/photos/7/26/72648/453-8-lap_sml.jpg)
AT88SC25616C-CI
Manufacturer Part Number
AT88SC25616C-CI
Description
IC EEPROM 256KBIT 1.5MHZ 8LAP
Manufacturer
Atmel
Series
CryptoMemory®r
Datasheet
1.AT88SC25616C-CI.pdf
(14 pages)
Specifications of AT88SC25616C-CI
Format - Memory
EEPROMs - Serial
Memory Type
EEPROM
Memory Size
256K (32K x 8)
Speed
5MHz
Interface
I²C, 2-Wire Serial
Voltage - Supply
2.7 V ~ 5.5 V
Operating Temperature
-40°C ~ 85°C
Package / Case
8-LAP
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Protocol Selection
Asynchronous
T = 0 Protocol
Synchronous
2-wire Serial Interface
5017CS–SMEM–6/04
The AT88SC25616C supports two different communication protocols.
•
•
The power-up sequence determines which of the two communication protocols will be used.
This power-up sequence complies with ISO 7816-3 for a cold reset in smart card
applications.
•
•
•
•
The device will respond with a 64-bit ATR code, including historical bytes to indicate the mem-
ory density within the CryptoMemory family. Once the asynchronous mode has been
selected, it is not possible to switch to the synchronous mode without powering off the device.
Figure 2. Asynchronous T = 0 Protocol
After a successful ATR, the Protocol and Parameter Selection (PPS) protocol, as defined
by ISO 7816-3, may be used to negotiate the communications speed with CryptoMemory
devices 32 Kbits and larger. CryptoMemory supports D values of 1, 2, 4, 8, 12, and 16 for
an F value of 372. Also supported are D values of 8 and 16 for F = 512. This allows selec-
tion of 8 communications speeds ranging from 9600 baud to 153,600 baud.
The synchronous mode is the default after powering up V
on RST. For embedded applications using CryptoMemory in standard plastic packages,
this is the only communication protocol.
•
•
•
•
Figure 3. Synchronous 2-wire Protocol
Note:
CLK-SCL
Smart Card Applications: The asynchronous T = 0 protocol defined by ISO 7816-3
is used for compatibility with the industry’s standard smart card readers.
Embedded Applications: A 2-wire serial interface is used for fast and efficient
communication with logic or controllers.
V
Set I/O-SDA in receive mode.
Provide a clock signal to CLK-SCL.
RST goes high after 400 clock cycles.
Power-up V
After stable V
Power-up V
After stable V
CLK-SCL
I/O-SDA
CC
I/O-SDA
Five clock pulses must be sent before the first command is issued.
goes high; RST, I/O-SDA and CLK-SCL are low.
RST
RST
V cc
V cc
CC
CC
CC
CC
, RST goes high also.
, RST goes high also.
, CLK-SCL and I/O-SDA may be driven.
, CLK-SCL and I/O-SDA may be driven.
1
2
3
4
5
AT88SC25616C
CC
due to the internal pull-up
ATR
5