DS3030W-100# Maxim Integrated Products, DS3030W-100# Datasheet - Page 17

• Manufacturer Part Number: DS3030W-100#
• Description: IC NVSRAM 256KBIT 100NS 256BGA
• Manufacturer: Maxim Integrated Products

Specifications of DS3030W-100#

• Format - Memory: RAM
• Memory Type: NVSRAM (Non-Volatile SRAM)
• Memory Size: 256K (32K x 8)
• Speed: 100ns
• Interface: Parallel
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

sible. Surface-mount components minimize lead induc-
tance, which improves performance, and ceramic
capacitors tend to have adequate high-frequency
response for decoupling applications.
Care should be taken to avoid simultaneous access of
the SRAM and RTC devices (see Figure 4). Any chip-
enable overlap violates t
and unpredictable behavior.
The IRQ/FT and RST outputs are open drain, and there-
fore require pullup resistors to realize a high logic out-
put level. Pullup resistor values between 1kΩ and 10kΩ
are typical.
The DS3030W charges an ML battery to maximum
capacity in approximately 96 hours of operation when
V
its lifetime depends primarily on the V
The DS3030W can maintain data from a single, initial
charge for up to 2 years. Once recharged, this deep-
discharge cycle can be repeated for up to 20 times,
producing a worst-case service life of 40 years. More
typical duty cycles are of shorter duration, enabling the
DS3030W to be charged hundreds of times, and
extending the service life well beyond 40 years.
The DS3030W can be cleaned using aqueous-based
cleaning solutions. No special precautions are needed
when cleaning boards containing a DS3030W module.
Removal of the topside label violates the environmental
integrity of the package and voids the warranty of the
product.
Figure 4. SRAM/RTC Data Bus Control
CC
is greater than V
3.3V Single-Piece 256kb Nonvolatile SRAM
CE
CS
Avoiding Data Bus Contention
Using the Open-Drain
TP
Battery Charging/Lifetime
Recommended Cleaning
. Once the battery is charged,
CCS
and can result in invalid
V
IH
and RST Outputs
____________________________________________________________________
t
CCS
CC
Procedures
duty cycle.
V
IRQ /FT
IH
Recommended Reflow Temperature
Profile
Note: All temperatures refer to topside of the package, mea-
sured on the package body surface.
Average Ramp-Up Rate
(T
Preheat
- Temperature Min (T
- Temperature Max (T
- Time (Min to Max) (ts)
T
- Ramp-Up Rate
Time maintained above:
- Temperature (T
- Time (t
Peak Temperature (T
Time Within 5°C of Actual Peak
Temperature (T
Ramp-Down Rate
Time 25°C to Peak Temperature
Smax
L
to T
PROFILE FEATURE
to T
P
L
)
)
L
V
IH
P
)
L
)
Smin
P
t
Smax
CCS
)
)
)
V
IH
with Clock
60 to 120 Seconds
60 to 150 Seconds
Sn-Pb EUTECTIC
10 to 30 Seconds
3°C/Second Max
6°C/Second Max
6 Minutes Max
ASSEMBLY
225 +0/-5°C
+183°C
100°C
150°C
17