AT17F080-30JU Atmel, AT17F080-30JU Datasheet - Page 7
![IC FLASH CONFIG 8M 20PLCC](/photos/6/80/68044/453-20-plcc_sml.jpg)
AT17F080-30JU
Manufacturer Part Number
AT17F080-30JU
Description
IC FLASH CONFIG 8M 20PLCC
Manufacturer
Atmel
Datasheet
1.AT17F040-30JU.pdf
(19 pages)
Specifications of AT17F080-30JU
Programmable Type
FLASH
Memory Size
8Mb
Voltage - Supply
2.97 V ~ 3.63 V
Operating Temperature
-40°C ~ 85°C
Package / Case
20-LCC (J-Lead)
For Use With
ATDH2225 - CABLE ISP FOR AT17ATDH2200E - CONFIGURATOR PROGRAM BOARD KIT
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
5.9
5.10
5.11
5.12
3039K–CNFG–2/08
A2
READY
SER_EN
V
CC
(1)
(1)
Device selection input, (when SER_EN Low). The input is used to enable (or chip select) the
device during programming (i.e., when SER_EN is Low). Refer to the AT17F Programming
Specification available on the Atmel web site for additional details.
Open collector reset state indicator. Driven Low during power-up reset, released when power-up
is complete. (recommended 4.7 kΩ pull-up on this pin if used).
The serial enable input must remain High during FPGA configuration operations. Bringing
SER_EN Low enables the 2-Wire Serial Programming Mode. For non-ISP applications,
SER_EN should be tied to V
+3.3V (±10%).
Notes:
1. This pin has an internal 20 kΩ pull-up resistor.
2. This pin has an internal 30 kΩ pull-down resistor.
CC
.
AT17F040/080
7