ABM1M-A-C Panduit Corp, ABM1M-A-C Datasheet - Page 4

• Manufacturer Part Number: ABM1M-A-C
• Description: 1/2"12.7MM 4 WAY ADHVE BCK MNT
• Manufacturer: Panduit Corp
• Type: Quad Openingr

Specifications of ABM1M-A-C

• Color: White
• Mounting Type: Adhesive
• Size / Dimension: 0.50" L x 0.50" W x 0.16" H (12.7mm x 12.7mm x 4.0mm)
• Mounting Method: Adhesive
• Height: 0.16 in
• Length: 0.5 in
• Width: 0.5 in
• Application: For making part orientation fast and easy, adhesive backing allows routing of wires and cables where mounting holes cannot be drilled
• Protection Class: Mount, Cable Tie
• Special Features: Adhesive Backed
• Body Material: Nylon 6.6 W/Rubber Adhesive Backing
• Accessory Type: 4-Way Adhesive Backed Cable Tie Mount
• Rohs Compliant: Yes
• For Use With/related Products: M Series
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: Panduits Nylon Cable Ties
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4
Proper Installation Steps
Surface Preparation
For best results, mounts should be applied to a clean, dry, and grease-free surface. It is recommended that for each individual application,
a solvent or cleanser be used to thoroughly prepare the surface for mount installation. The following are recommended cleaning guidelines:
Installing the Mount
9
12
6
Alcohol
3
1. For Rubber and Acrylic-based Adhesive Foam Tape, a mixture of water and isopropyl alcohol may be used on
2. Allow the surface to dry completely before applying the mount.
1. For proper installation of adhesive backed mounts with foam tape, remove the release liner from the foam
2. Apply firm pressure for five (5) seconds to the foam tape mounts to insure proper adhesion.
3. Allow the mount to remain in place for the recommended dwell time for the specific adhesive being used.
4. The mount is now ready to be used.
most surfaces.
For Two-part Epoxy Adhesive, especially on masonry surfaces, be sure to clean all loose particles away before
mount installation. Some surface abrasion is recommended on smooth surfaces to achieve maximum strength.
A light rubbing with medium grit emery cloth or sandpaper is best. Wash the surface after abrading.
adhesive. Without touching the adhesive, place the mount in the desired location.
For Two-part Epoxy Adhesive Mounts, apply 1/3 of the mixed adhesive to the bottom of the PANDUIT
ASMS mount. Without touching the adhesive, place the mount in the desired location.
Two-part Epoxy Adhesive Mounts should be twisted in place to ensure the adhesive is forced into the
porous surface.
The dwell time for Rubber-based Adhesive Foam Tape is two (2) hours and for Acrylic-based Adhesive Foam
Tape it is eight (8) hours.
Two-part Epoxy Adhesive Mounts can support about 5 lbs. after first fifteen (15) minutes. The adhesive fully
cures after twenty-four (24) hours and bonding strength will exceed 50 lbs.
®
EMS or