LM2794TL/NOPB National Semiconductor, LM2794TL/NOPB Datasheet - Page 9

• Manufacturer Part Number: LM2794TL/NOPB
• Description: IC LED DRVR WHT BCKLT 14MICROSMD
• Manufacturer: National Semiconductor
• Type: Backlight, White LEDr

Specifications of LM2794TL/NOPB

• Constant Current: *
• Constant Voltage: *
• Topology: *
• Number Of Outputs: *
• Internal Driver: *
• Type - Primary: *
• Type - Secondary: *
• Frequency: *
• Voltage - Supply: *
• Voltage - Output: *
• Mounting Type: Surface Mount
• Package / Case: 14-MicroSMD
• Operating Temperature: *
• Current - Output / Channel: *
• Internal Switch(s): Yes
• Efficiency: 80%
• No. Of Outputs: 4
• Output Current: 80mA
• Input Voltage: 2.7V To 5.5V
• Dimming Control Type: PWM / Analog
• Operating Temperature Range: -30°C To +85°C
• Switching Frequency: 515kHz
• Rohs Compliant: Yes
• For Use With: LM2794EVAL - BOARD EVALUATION LM2794
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: LM2794TL/NOPBTR

Functional Block Diagram
Application Information
CIRCUIT DESCRIPTION
The LM2794/5 is a 1.5x/1x CMOS charge pump with four
matched constant current outputs, each capable of driving
up to 20mA through White LEDs. This device operates over
the extended Li-Ion battery range from 2.7V to 5.5V. The
LM2794/5 has four regulated current sources connected to
the device’s 1.5x charge pump output (P
ages below 4.7V (typ.), the charge-pump provides the
needed voltage to drive high forward voltage drop White
LEDs. It does this by stepping up the P
the input voltage. The charge pump operates in Pass Mode,
providing a voltage on P
the input voltage is at or above 4.7V (typ.). The device can
drive up to 80mA through any combination of LEDs con-
nected to the constant current outputs D
To set the LED drive current, the device uses a resistor
connected to the I
SET
pin to set a reference current. This
OUT
equal to the input voltage, when
OUT
1
OUT
-D
voltage 1.5 times
4
). At input volt-
.
9
reference current is then multiplied and mirrored to each
constant current output. The LED brightness can then be
controlled by analog and/or digital methods. Applying an
analog voltage in the range of 0V to 3.0V to the Brightness
pin (BRGT) adjusts the dimming profile of the LEDs. The
digital technique uses a PWM (Pulse Width Modulation)
signal applied to the Shutdown pin (SD). (see I
BRGT PINS section).
SOFT START
Soft start is implemented internally by ramping the reference
voltage more slowly than the applied voltage. During soft
start, the current through the LED outputs will ramp up in
proportion to the rate that the reference voltage is being
ramped up.
www.national.com
SET
20028530
and