CAT9532WI-T1 ON Semiconductor, CAT9532WI-T1 Datasheet - Page 6

• Manufacturer Part Number: CAT9532WI-T1
• Description: IC LED DRIVER LINEAR 24-SOIC
• Manufacturer: ON Semiconductor
• Type: Linear (I²C Interface)r

Specifications of CAT9532WI-T1

• Topology: Open Drain, PWM
• Number Of Outputs: 16
• Internal Driver: Yes
• Type - Primary: Backlight, LED Blinker
• Type - Secondary: RGB
• Frequency: 400kHz
• Voltage - Supply: 2.3 V ~ 5.5 V
• Mounting Type: Surface Mount
• Package / Case: 24-SOIC (7.5mm Width)
• Operating Temperature: -40°C ~ 85°C
• Current - Output / Channel: 25mA
• Internal Switch(s): Yes
• Number Of Segments: 16
• Low Level Output Current: 25 mA
• Operating Supply Voltage: 2.3 V to 5.5 V
• Maximum Supply Current: 550 uA
• Maximum Power Dissipation: 1 W
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Output: -
• Efficiency: -
• Lead Free Status / Rohs Status: Details
• Other names: CAT9532WI-T1TR

CAT9532
AC TEST CONDITIONS
PIN DESCRIPTION
SCL: Serial Clock
The serial clock input clocks all data transferred into
or out of the device. The SCL line requires a pull-up
resistor if it is driven by an open drain output.
SDA: Serial Data/Address
The bidirectional serial data/address pin is used to
transfer all data into and out of the device. The SDA
pin is an open drain output and can be wire-ORed
with other open drain or open collector outputs. A pull-
up resistor must be connected from SDA line to V
Doc. No. MD-9001 Rev. E
Input Pulse Voltage
Input Rise and Fall Times
Input Reference Voltage
Output Reference Voltage
Output Load
SDA OUT
SDA IN
SCL
t SU:STA
t F
Figure 1. 2-Wire Serial Interface Timing
t HD:STA
t LOW
0.2V
≤5ns
0.3V
0.5V
Current source: I
t AA
t HD:DAT
t HIGH
CC
CC
CC
, 0.7V
to 0.8V
CC
.
CC
t LOW
CC
6
OL
LED0 to LED15: LED Driver Outputs / General
Purpose I/Os
The pins are open drain outputs used to drive directly
LEDs. Any of these pins can be programmed to drive
the LED ON, OFF, Blink Rate1 or Blink Rate2. When
not used for controlling the LEDs, these pins may be
used as general purpose parallel input/output.
¯¯¯¯¯¯ : External Reset Input
RESET
Active low Reset input is used to initialize the
CAT9532 internal registers and the I
The internal registers are held in their default state
while Reset input is active. An external pull-up resistor
of maximum 25kΩ is required when this pin is not
actively driven.
= 3mA; 400pF for f
t DH
t SU:DAT
t R
SCL(max)
Characteristics subject to change without notice
= 400kHz
t SU:STO
t BUF
© 2010 SCILLC. All rights reserved
2
C state machine.